0
What else can I help you with?
How many liters in 1-tonne of fuel?
1159
How many kilometers can it travel on 10.00 liters of fuel if the car averages 45 miles per gallon of gas?
191.3 km on 10.00 liters of fuel @45 miles per gallon.
How many liters for 1km?
It depends on the fuel efficiency of your mode of transport.
How many liters of jet fuel make a metric ton?
1,183 litres of jet fuel in a metric tonne
How many liters of fuel per second does an Airbus A380 burn?
The airline says the plane burns just 3.1 liters of fuel per passenger per 100 kilometers (a little more than three quarts of fuel per passenger every 60 miles).
How much pressure on electric fuel injection fuel pump for 1992 b2200 Mazda pickup?
92 b2200 ,fuel injection psi should be 38 to 46 psi
Where is the fuel pressure regulator in a 1993 Mazda mx3?
The fuel pressure regulator is located on the fuel rail of the vehicle.
Is there a fuel pressure relief valve on a 1999 Mazda miata?
The 1999 Mazda Miata is a returnless fuel system. It has a Fuel Pressure Regulator in the tank (above the fuel pump), and a snub at the end of the fuel rail.
How does the fuel regulator on a Mazda mx3 work?
By regulating the fuel pressure
What is the fuel capacity of a 1992 Mazda b2200?
14.8 gallons
Where is the fuel pump on a 1992 Mazda Protege?
In the gas tank.
Where is the fuel filter on a 1992 Mazda B2200?
the fuel filter is located along the frame on the drivers side
Where is the fuel pump on a 1992 Mazda MPV located?
inside the gas tank
What is the recommended fuel pressure on a 1995 Mazda Millenia?
39-48psi
What is the fuel tank capacity for a 1999 mazda protege?
The fuel tank capacity for a 1999 Mazda Protege is approximately 13.2 gallons (50 liters). This capacity allows for a reasonable driving range, depending on the vehicle's fuel efficiency.
Where is the fuel pressure regulator on a 1992 Saturn?
The fuel pressure regulator is located on the fuel rail right in front of the intake manifold.
How do you install fuel injectors for 1992 Mazda miata?
To install fuel injectors on a 1992 Mazda Miata, start by disconnecting the negative battery terminal and relieving the fuel pressure by removing the fuel pump fuse and running the engine until it stalls. Next, remove the intake manifold and disconnect the fuel rail from the injectors. Carefully pull out the old injectors from the fuel rail and replace them with new ones, ensuring O-rings are lubricated. Finally, reassemble everything, reconnect the battery, and check for leaks before starting the engine.
