A force variable meter is a kind of electrodynamometer development when it is made with two mobile curls set at right edges to one another. The strategy for association of this sort of force component meter, in a 3phase circuit. The two stationary loops, S and S1, are associated in arrangement in Phase B. Curls M and M1 are mounted on a typical shaft, which is allowed to move without limitation or control springs. These loops are associated with their arrangement resistors from Phase B to Phase An and from Phase B to Phase C.
100 cm. = 1 meter. To convert from centimeters to meters, divide by 100.
Because you have been informed wrongly. It is impossible to convert square metres to linear metres.
Prefix 'centi' is used to denote sub multiples of meter and uses factor 10-2 or 0.01 In order to convert meters to centimeters, value of meters has to be divided by factor used with prefix 'centi': 1 meter = 1 / 10-2 = 1 / 0.01 = 100 centimeters
1 cubic meter = 1 kilolitre
The conversion factor is approximately 10.764 square feet per square meter. This is derived from the conversion 1 meter = 3.2808399 feet.
Multiplication factor can be derived from Meter CT, Meter PT, Connected CT and Connected PT values.
divide by 10001 meter = 1000 millimeters 1 millimeter = 0.001 meter
power factor meters are connected across the supply
The conversion factor from lux to watts per square meter (W/m2) is 1 lux 1 watt per square meter.
bunny rabits edit : Current usage
In a distortion factor meter the filter at the front end is used to suppress which type of hormonics
The conversion factor between inches and meters is 39.37 inches in 1 meter.
The K Factor in Current Transformer Metering is the Multiplyer. The current transformers might be a winding ratio of 200/5 therefore the K Factor would be 40. Meaning for every 100Amps in the meterered conductors only 2.5A is read by the meter the resultant reading is then multiplied by 40 to give the reading of 100A (or the calculated kWh reading for electricity consumption)
multiplying factor = Line CT Ratio / Meter CT Ratio Usually it is mentioned on Meter that MF = 1 if CT Ratio is 200/5 or MF = 2 if CT Ratio is 400/5. There can be an additional multiplication factor that would be mentioned on the meter.
A wattmeter reads the true power of a load, regardless of its power factor.
Check the conversion factor: 1 mm = 1/1000 metres.
Prefix 'centi' is used to denote sub multiples of meter and uses factor 10-2 or 0.01 To convert meter to centimeter, value of meters has to be divided by factor used with prefix 'centi': 1 meter = 1 / 10-2 = 10 / 0.01 = 100 centimeter