answersLogoWhite

0


Best Answer

For standard type rupture disc devices the leak tightness is typically 1 x 10-3 mbar.l/sec He or better, when applying O-ring seals between the rupture disc and its holder (if approved by the manufacturer!) then 1 x 10-6 mbar.l/sec is achievable. Higher leak rates will require welded type rupture discs where 1 x 10-8 mbar/le/sec or better will be feasable.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is rupture disc leak tightness?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Describe a herniated vertebral disc due to whiplash injury?

A herniated disc occurs when the outer layer of the disc is damaged, the disc may rupture and the gel-like interior leak, putting pressure on adjacent nerve roots causing tingling, numbness or burning.


How do you know if ihave a gas leak?

Do a tightness test on your gas meter and the presure will drop if you have a leak.


What are other names for a herniated disc?

A herniated disc is also referred to as a slipped, rupture, bulging, or protruding disc.


Would herniated disc in the neck cause a tightness feeling?

yes


Where is the rupture disc located on a low pressure chiller?

the rupture disc is piped off the chiller barrel (evaporator) and will vent the refrigerant outside incase of over pressure of the unit


How rupture disc fitted in steam condenser?

A rupture disc is mounted between two pipe flanges, one mounted to the condenser the other either unmounted or mounted to a vent pipe.


What is a herniatic disc?

As the spinal disc becomes less elastic, it can rupture. When the disc ruptures, a portion of the spinal disc pushes outside its normal boundary--this is called a herniated disc.


Is the pressure in a hydraulic jack the same everywhere?

No, it will depend on leak-tightness, viscosity of oil etc.


What is premature rupture of membranes in prematurity or premature birth?

Premature rupture of membranes occurs when the amniotic sac is torn, causing the amniotic fluid to leak out.


What is reherniation?

Well, a herniated disc or "slipped disc" is when an intervertebral disc, (the cushions that sit between each vertebra of our spine) may slip out of place or rupture. If pressing on a nerve this may cause severe pain.


Where is the rupture disc located on a low pressure chiller picture?

The rupture disc on a low pressure chiller is typically located on the refrigerant circuit close to the compressor. It is designed to release pressure in the event of an overpressure situation to prevent damage to the system. The exact location can vary depending on the chiller's design and manufacturer.


Does screw tightness effect gun function?

Yes. If screws are too loose then air can leak, and overtightening may strip screws.