answersLogoWhite

0

Take Off's are meant for what is the take off of a 10'' 90.that would be 15''.a standard long radius 90 will be one and half times the diameter of the pipe.8'' would be 12''a short radius fitting would be different.the system this is it=1.2.1.2. works well.

User Avatar

Wiki User

14y ago

What else can I help you with?

Continue Learning about Math & Arithmetic

How do you calculate pipe takeoff?

To calculate pipe takeoff, first measure the total length of the pipe needed, considering all fittings and bends. Then, determine the pipe's diameter and material, as these factors influence the amount of material required. Use the formula for the volume of a cylinder (V = πr²h) to calculate the volume of the pipe, adjusting for any fittings. Finally, convert the volume to weight using the material's density if necessary, ensuring to account for any waste or scrap in your calculations.


What is the formula for calculating the takeoff for odd degree elbows?

The formula for calculating the takeoff for odd degree elbows in piping systems is typically given by: [ \text{Takeoff} = \frac{\text{Diameter} \times \tan(\frac{\theta}{2})}{2} ] where (\theta) is the angle of the elbow in degrees, and the diameter is the nominal pipe diameter. This formula helps determine the length of pipe needed for installation around the bend. Adjustments may be necessary based on specific application requirements or standards.


What's the takeoff for a 30 degree angle?

The takeoff for a 30 degree angle will depend with the offset angle.


What is takeoff measurement on a 4 inch victaulic 90?

Takeoff measurement for a 4-inch Victaulic 90-degree elbow typically refers to the distance from the centerline of the pipe to the end of the fitting. For a standard 4-inch Victaulic elbow, this measurement is generally around 4 inches, but it can vary slightly based on the specific manufacturer and design. Always consult the manufacturer's specifications or installation guidelines for precise measurements.


How do you calculate volume of water in a pipe?

measure the radius of the pipe. (half the diameter - the width of the pipe) then measure the length of the pipe. then use the formula pi (3.14) x radius2 x length. the answer is the volume in the pipe

Related Questions

What is the takeoff for six pipe?

3"


What is pipe takeoff?

size of pipe divide to 2 three times


What is the takeoff for 8 inch pipe?

16


How do you calculate pipe takeoff?

To calculate pipe takeoff, first measure the total length of the pipe needed, considering all fittings and bends. Then, determine the pipe's diameter and material, as these factors influence the amount of material required. Use the formula for the volume of a cylinder (V = πr²h) to calculate the volume of the pipe, adjusting for any fittings. Finally, convert the volume to weight using the material's density if necessary, ensuring to account for any waste or scrap in your calculations.


When was Takeoff - film - created?

Takeoff - film - was created in 1979.


How are the ailerons used at takeoff?

they help an airplane bank (turn) after they takeoff


What is the duration of Takeoff film?

The duration of Takeoff - film - is 2.32 hours.


Does the F-22 have vertical takeoff?

No. The F-35 which looks similar can takeoff and land vertically.


Is the airplane takeoff controlled by the propellers or the wheels?

The aeroplane takeoff is controlled by the engine speed and the elevators.


Can you turn off airplane mode after takeoff?

Yes, you can turn off airplane mode after takeoff.


Can I turn off airplane mode after takeoff?

Yes, you can turn off airplane mode after takeoff.


What is balanced field takeoff?

A "balanced field" with respect to aircraft takeoff performance refers to the minimum length of runway that will allow for an aircraft to accelerate to V-1 (decision speed), experience failure of the critical engine, and then either stop in the remaining runway or continue to a successful takeoff meeting all applicable takeoff performance criteria.