answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What is the 1st dot cube?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How many different numbers can you roll with one dot cube?

If it was 1 one dot cube, you could only roll 1 number. If it was one dot cube. You could roll 6 numbers.


Gaming cube with dot on it?

Jared Torres


What is the probability that a rolled dot cube will stop with exactly two dots on top?

The probability of rolling a dot cube and stopping with exactly two dots on top is 1/6, because there are 6 possible outcomes when rolling a dot cube (1, 2, 3, 4, 5, 6) and only one of those outcomes has two dots on top.


What is the probability of rolling a composite number with one roll of a dot cube?

It is 1/3.


What was the 1st gaming system?

the cube


What is the sum of the 9th square number and the 1st cube number?

88


Notes for English literature for ba 1st year?

I have posted my notes in this blog www dot literaryinterpretation dot co dot cc.


What is the sum of the 14th square number and the 1st cube number?

6


In cube colossus how do you get Excalibur?

beat 19 lv using 1st weapon :D


What are the 1 5 cube numbers?

If the question is, "What are the 1st 5 cube numbers?" Then : 13 = 1 ; 23 = 8 ; 33 = 27 ; 43 = 64 and 53 = 125.


What is the surface area of a cube that's 1.5mm by 4mm by 10.5mm?

1st, it is not a cube, all sides of a cube are equal. 2nd rectangular solids, A = 2lw + 2lh+ 2wh 2x1.5x4 + 2x1.5x10.5 + 2x 1.5x10.5 = 127.5 square mm


How do you calculate the density of a six sided die?

A die is basically a cube. Calculate density by measuring the volume of the cube and dividing that into the weight of the cube. The volume can be calculated using the formula for a cube. Let's assume the holes in the faces are negligible. All three sides of a cube(Length, width and height) are the same length. Volume = length of side X length of side X length of side Measure the weight of the die. Density = Weight / Volume If the dots on the die are cut out, then you can get a little more accurate by measuring the size of the dot and calculating the depth. Then you would try to calculate the volume of a dot on the die. Then subtract this volume for each of the dots on the faces of the die. There are 21 dots(I think).