Want this question answered?
Be notified when an answer is posted
The cord of a circle that contains the center of that circle is a diameter of that circle.
4.25 inches
the answer is 20
L=L(initial)[1+C(al)]*T =1.184cm I can't figure out the second one either
Center
CD's have a diameter of 5.5 centimeters;)
15 mm
The center of the rim is 66.1mm in diameter on a 2005-2008 Nissan Frontier.
The center line of a hole measuring 1 inch in diameter would be located 0.5 inches from the edge of the hole in all directions. This line represents the midpoint of the hole and is essential for accurate positioning and measurements.
The diameter is 0.286". Which, by the way, does not correspond to any standard size drill in English or metric units, but that's what it is. If there is an explanation for this I haven't seen it.
18mm It was decided in a meeting by someone putting a coin from the Netherlands on the table and said that size would do.
It is physically impossible to remove an object from a hole that goes through the diameter of the Earth, as it would require traveling through the Earth's center which is inaccessible to humans. Additionally, the extreme temperatures and pressures at the Earth's core would make survival impossible.
4.24563 inches is the diameter of a golf hole.
It is 6 inches in diameter located in the center of the board and 9 inches from the top of the board to the center of the hole. For cornhole board design ideas check out: http://www.cornholeace.com/cornhole-board-designs.php
The cord of a circle that contains the center of that circle is a diameter of that circle.
Diameter: 2*6 = 12 inches
On a five bolt pattern measure from outer edge of one bolt then across to the middle of another skipping one bolt hole( not quite the diameter). On six or four bolt patterns measure across from bolt center to bolt center as you would the diameter if it were a circle.