0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
In math what is the graident?
gradient in math refers to the slope of a line
What is a line segment used for?
A line segment is often used in math to do geometry and other types of math. This is a part of a line which can be calculated and measured correctly in an equation.
What is the meaning of line plot in math?
a line plot is a line that shows arrays on a line. you get data based on it.
What does line mean in math form?
the mean (in math) is the average of all the numbers in the problem
What is a figure line?
Listen in math class
What maths is used in tire fitting?
The math used in tire fitting is algebra. Math helps to determine the size of the tire needed for each vehicle.
What is a best-fit line as a math definition?
Best-fit line is used in a graph with a whole bunch of dots. If the dots are grouped up and that they are all going in a direction if there is one then there should be a best-fit line which is only a line going down there path to point that it's not changing.
What is the use of best - fit line in math for a job?
A teacher teaches it to kids.
Can you use Compression fitting on a brake line?
NO!
You have transmission fluid leaking from your coolant line on a 1999 GMC 2.2L Sonoma The line is properly flared but it will not stay tight in the fitting?
Replace the fitting.
How do you stop the heater line that goes in the intake manifold from leaking?
You will need to replace the quick disconnect fitting and it is best to use a steel one.
Where to locate fuel filter on 1984 Chevy c10 truck?
If you look at the front of the carburetor you will see a medal line that is screwed into a 1 inch fitting. You will need to remove the line from the fitting with a 5/8 wrench and then remove the 1 inch fitting and the filter will be behind that fitting.
Where do you find the fuel filter in an 86 Olds cutlass?
ABOUT CENTER TO THE CARBERATOR YOU WILL SEE A HARD LINE (FUEL LINE) SMALL LINE SCREWED INTO LARGER FITTING BEHIND THE LARGER FITTING THERE IS A SMALL 1 1/4 INCH FUEL FILTER INSIDE OF LARGER FITTING
Where is fuel filter on 1978 Chevy K-10 Silverado?
If you look at the front of the carburetor you will see a big medal line screewed into a 1 inch fitting, the line is a 5/8 fitting and the filter is behind the 1 inch fitting.
What causes an offset sewer line?
Various fitting degrees
How do you remove a stuck fuel hose?
you will have to explain a little more are you describing a fitting with a clip or just a clamped rubber line on a barb fitting? if a clamped fitting take pliers and grab on fitting enough to turn hose back and forth it will usually pop free. if with a clip fitting you have to take the lock clip out from behind the flange and it should release if not you may have to cut the fitting out and replace it if it is a metal line there should be two fittings you put two wrenches on and turn in opposite directions again if the are too tight you may have to pipe cut the line and splice with a rubber piece of fuel line
How do you remove the quick connect on the transmission line of a Chevy s10?
There is a plastic fitting or tool that goes around the line and you push into the fitting to release it. Push it in and pull out the line. You can buy a set of 5 for around $8 to $10 U.S.
