The center of a wheel or circle is called a hub.
polyp
It's called a hub.
28 - 21 = 7Which is a fairly silly answer as there are no 21" bike wheels. The spoke thing is quite misleading, as there are several things that aren't mentioned here that affect spoke length.If stood side by side the 28" wheel will reach 7" higher than the 21" wheel.7 inches difference . As 28-21=7The diameter of one bicycle wheel is 28 inches and its spokes run from the hub (or center) to the edge of the rim. The diameter of another bicycle wheel 21 inches. What is the difference in inches between the length of the spokes of the two wheels?
None. A wheel, be definition, is circular and therefore has no vertices!
To accurately measure the size of a bicycle wheel, use a tape measure to determine the diameter of the wheel from one edge of the tire to the other. Make sure to measure from the center of the wheel for accuracy. The size of a bicycle wheel is typically expressed in inches or millimeters.
I think you looking for a bicycle called the Penny-farthing, an early design of bicycle that had a very large front wheel.It is called a penny-farthing. Called that because the difference between the big wheel and the small wheel was similar to the difference between the old British pre-decimal penny and the farthing.
To remove a Shimano freehub from a bicycle wheel, you will need a special tool called a cassette lockring remover. First, remove the wheel from the bike. Then, insert the lockring remover into the center of the freehub and turn it counterclockwise to loosen the lockring. Once the lockring is removed, the freehub should slide off the wheel axle.
The center of a wheel or circle is called a hub.
The gears on the rear wheel are called a cassette
bicycle with a basket
To properly center a bicycle wheel, you need to adjust the tension of the spokes on both sides of the wheel. Use a spoke wrench to tighten or loosen the spokes until the wheel is centered between the fork or frame. Spin the wheel and check for any wobbling or rubbing against the brake pads. Repeat the process until the wheel spins true and straight.
To measure a bicycle wheel accurately, use a tape measure to find the diameter of the wheel from one edge of the tire to the other. Make sure to measure from the center of the wheel for accuracy. This measurement will give you the size of the wheel, typically in inches or millimeters.
The term for lifting the front wheel of a bicycle off the ground while balancing on the rear wheel is called a "wheelie."
To remove a cassette from a bicycle wheel, you will need a cassette removal tool and a wrench. First, remove the wheel from the bike. Then, insert the removal tool into the center of the cassette and use the wrench to turn it counterclockwise to loosen and remove the cassette from the wheel.
To measure bicycle wheel size accurately, use a tape measure to determine the diameter of the wheel from one edge of the tire to the other edge, passing through the center of the wheel. Make sure to measure in millimeters for precision.
Tyre