shape will be changed
distinguish between dispersion and skewness
difference
The Absolute Measure of dispersion is basically the measure of variation from the mean such as standard deviation. On the other hand the relative measure of dispersion is basically the position of a certain variable with reference to or as compared with the other variables. Such as the percentiles or the z-score.
Absolute dispersion usually refers to the standard deviation, a measure of variation from the mean, the units of st. dev. are the same as for the data. Relative dispersion, sometimes called the coefficient of variation, is the result of dividing the st. dev. by the mean, hence it is dimensionless (it may also be presented as a percentage). So a low value of relative dispersion usually implies that the st. dev. is small in comparison to the magnitude of the mean, as in a st. dev. of 6cm for a mean of 4m would give a figure of 0.015 (1.5%) whereas with a mean of 40cm it would be 0.15 or 15%. However with measurements either side of zero and a mean close to zero the relative dispersion could be greater than 1. As is usual, interpret with caution.
difference between as on and as at
distinguish between dispersion and skewness
dispersion medium is contained
difference
Distortion.
The spectrum analyzer is used to do distortion analysis to the signal. Due to the fact that we don't have a pure generated signal. In reality, there must be some distortion. The distortion analysis is important in the communication field as well as in electronics.
the frequency difference between the transmitter and the receiver without any noise or distortion
Pincushion distortion and barrel distortion are both types of optical distortions that occur in images. Pincushion distortion causes the image to appear pinched inwards towards the center, while barrel distortion causes the image to bulge outwards towards the edges. The main difference between the two is the direction in which the distortion occurs - pincushion towards the center, and barrel towards the edges.
The Absolute Measure of dispersion is basically the measure of variation from the mean such as standard deviation. On the other hand the relative measure of dispersion is basically the position of a certain variable with reference to or as compared with the other variables. Such as the percentiles or the z-score.
Dispersion refers to the separation of different wavelengths of light as they travel through a medium, causing them to spread out. Spectrum refers to the range of colors produced when white light is separated into its component colors through dispersion. In essence, dispersion causes the formation of a spectrum of colors.
Measures of central tendency are averages. Range , the difference between the maximum and the minimum, is a measure of dispersion or variation.
Yes, NCl3 does exhibit dispersion forces. Even though it is a polar molecule with a permanent dipole moment due to the difference in electronegativity between nitrogen and chlorine, it also experiences temporary fluctuations in electron distribution that can induce temporary dipoles in neighboring molecules, leading to dispersion forces.
The output waveform will be limited to the difference between the supply and ground (or between the positive and negative supplies). This causes distortion of the output waveform.