Wiki User
∙ 12y agoThe radius
Wiki User
∙ 12y agoit is called the "center"
It is a marking gauge.
A set square is a tool for marking angles in engineering and technical drawing, etc. They come in different angles and may be adjustable.
Well, if the measuring jug is large enough, all you need to do is fill it with water high enough that you can completely submerge yourself. Measure the water level before and after you get in, using the marking pencil. The distance between the two marks is your volume.
you are concerned with marking and drilling the the center of the hole. Make a + mark where you want the center of each hole. You can punch the center of that mark with a nail to help the bit stay in the middle.
It is the radius
The distance between the pivot point and the marking point of a compass is the radius of the circle being drawn.
it is called the "center"
Clear and dimensional accuracy in marking out is critical in all circumstances. You spend the time marking something out then you or others should be able to see it clearly. Drawing requirements must be followed at all times you mark out to the tolerance the drawing states.
A drawing or marking that represents a feature on a map is called a symbol. These markings make up the map key.
Symbol/Symbols
oh
it is for marking and measuring a distance
It would be a hole punch.
It is a marking gauge.
Folding the paper and aligning marks seen through them marking points Drawing line segments apex.
The middle thing on a compass is called the compass rose. It is the circular marking that shows the cardinal directions (north, south, east, west) and sometimes intermediate points on a map or compass.