0
Add your answer:
Earn +20 pts
Will it be damaging to use a 5 amphere power adapter to a 3 amphere unit?
No. As long as the voltage specs match. The load will only draw the current it needs to operate. If the current specs were flipped, 3A adapter on a 5A unit, this would cause problems. The unit will try to draw the 5A it's designed for and smoke the adapter.
How do you answer a percent?
1/100 is equivalent to 1%, which is equivalent to .01. In another example, 1/25 is equivalent to 4%, which is equivalent to .04.
Is 1 over 10 equivalent?
It can be. 1/10 is equivalent to 2/20
What is the equivalent decimal of 1 hundredth?
equivalent decimal of 1 hundredth = 0.01
What number is not equivalent to 1 25?
Any number which is not 1/25 or 0.04 is not equivalent to 1/25.
For a device requiring DC 12v 1000mA will a DC adapter with output 12v 2.7A also work?
No, because the provided rating of 12volt, 2.7Amp equivalent to 2700 mA (milli amphere) is a much higher as to the adapter said 12volt, 1000 mA (Milli Amphere).
What is the abbreviation for the electrical term amp?
amphere
How you find out amphere only if you know kilowatts?
Kilometers
What is the meaning of 850va inverter?
vA MEANS VOLTS AMPHERE
Reduction factor of tangent galvanometer?
it is the current measured in amphere..
Do you need to calibrate a multimeter?
measure the voltage,amphere resestance
What is the term amphere mean?
An ampere, typically abbreviated as "amp," is the unit of measurement for electrical current. It represents the rate at which electric charge flows in a circuit.
How much rating ammeter required in rcu for 75 kw motor?
200 amphere
What do ammeters mesure?
ammeter measures the current flowing through the circuit in the unit of amphere.
When setting up a breaker box how do you determine circuit breaker capacity?
find amphere required
How much amphere hour will be needed to start a 9.5 kw motor?
Not enough information the voltage is needed also.
Will it be damaging to use a 5 amphere power adapter to a 3 amphere unit?
No. As long as the voltage specs match. The load will only draw the current it needs to operate. If the current specs were flipped, 3A adapter on a 5A unit, this would cause problems. The unit will try to draw the 5A it's designed for and smoke the adapter.
