0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the function of a mere?
To hold water. A mere is a lake.
What is the function of a clay triangle in a laboratory?
The clay triangle is used to hold a crucible while thecrucible is heated
What is function of the gubernaculum?
This part of the body can be found in men and women. In men it helps in the descent of the testes and it also serves to hold them in place inside the scrotum. In women it helps support the ovary and uterus.
Is it true that discriminant can hold all the quadratic function?
I dont even know my times tables yet!! im only 4
Is the relation a function?
Not every relation is a function. But every function is a relation. Function is just a part of relation.
What is the signal used for DMA in 8085?
The HOLD pin indicates that an external device wants the 8085 to stop and allow the external device to drive the bus. The acknowledge of control transfer is HLDA, however, it is important to note that HLDA does not mean the current cycle is complete - it means that the current cycle is the last cycle, at which point the 8085 will release the bus. (One half clock cycle later.)
What is function of hold pin in 8085 microprocessor?
The HOLD pin on the 8085 is an external request for control of the bus. Upon receipt of HOLD, the 8085 will complete its current cycle and assert HLDA (HOLD Acknowledge), and then it will float the address, data, and control bus one half clock cycle later. The external hardware is then free to use the bus. When it is done, it releases HOLD, the 8085 releases HLDA, and the 8085 takes control of the bus and continues with the next cycle. HOLD is used by external DMA controllers, such as the 8257, to transfer data to and from memory on behalf of high speed peripherals, without requiring 8085 attention to that data transfer.
What is DMA in 8085 in microprocessor?
DMA stands for Direct Memory Access, in regards to 8085 MP. It consists of 2 pins, namely, HOLD and HLDA. The former of which indicates the processor that either a peripherial or any IO device, is requesting the processor to hold its current activites and give the control of buses to IO devices. HLDA, on the contrary, is the acknowledgement from the microprocessor to the concerned IO device sending the request.
Basic DMA operation and 8237 DMA Controller?
In the 8085, DMA (Direct Memory Access) is controlled with HOLD and HLDA. The HOLD signal is a request to release the bus. The HLDA signal is the 8085's acknowledgement of that request. HLDA means that the 8085 will release the bus in one half clock cycle, i.e. at the end of T3. The 8085 will remain in that hold state until HOLD is released, at which point it will take control of the buses again. The HOLD'ing device has complete control and can access any memory or I/O. Often, the 8237 DMA controller is used to provide sequencing of the operation. The 8237 DMA controller interfaces between up to four peripheral devices and the 8085. It provides an address register for each device so that the device does not need to do so. The device only needs to indicate that a byte of data is available, or is required, and the 8237 will take care of storing or fetching the byte.
What is function of ladle?
the function of ladle is to hold a liquid food
What is the function of the pelvic bone?
The function of the pelvis is to hold your legs and spine up.
What is the function of classroom?
the function of a classroom is to hold the students, so they can learn
What is the function of folder?
To hold anything
What is function of stage?
To hold the specimen or slide
Function of draw tube?
to hold the eyepiece
What the function of the filament?
To hold up the anther
What is the function of the diaphragm on microscope?
to hold the light
