"Equal to" is a comparator. "Not equal to" is also a comparator.The following comparators are also used to compare scalar quantities:less thanless than or equal togreater thangreater than or equal to
fundamental of bar sinus to measure the angle
Not every relation is a function. But every function is a relation. Function is just a part of relation.
The cubic function.
Range
A comparator is simply an opamp with a certain configuation of external circuitry ( a few components) that make it function as a comparator.
product of all transfer function relating input and output when the feedback loop is disconnected from the comparator
The correct spelling is "comparator."
com[arator is apricision instrument it is used to compare the actual size of workpeice there r 4 types of comparator 1: mechanical comparator 2:electrical comparator 3:optical comparator 4:penumatic comparator
it is a mechanical comparator with magnification in range of 300 to 5000
The basic function of a comparator in a PLC (Programmable Logic Controller) is to compare two input signals and determine if they are equal or if one is greater than the other. It typically outputs a boolean value (true or false) based on the comparison result. This comparison operation is used for decision-making within the PLC program, allowing for control and automation of processes based on the input conditions.
2 bit comparator = 1bit magnitude comparator +1 bit magnitude comparator if A>B =A(~B)(B bar); if A<B = ~A.B; A==B = AB + (~A)(~B); block of instruction shown above is for 1 bit comparator means if A>B ==true then High bit is set on (A>B) output. if A<B true then high bit is set on (A==B) output, If we cascade two 1 bit comparator then we can design 2-bit comparator...
Not sure about the comparator. XOR is what I came up with, so we have two XORs. This is the "exclusive OR" logic function. Build one out of standard resistors and transistors, or buy an IC with the XOR function already implemented, or use four two-input NAND gates. At least that's the way we did it in the 1960s. In analog circuits, a comparator.
A Schmitt trigger is very similar to a comparator -- both have analog input and send out either a "high" or "low" digital output. A comparator senses the difference between its "+" and "-" inputs. If the "+" input is even a little bit higher than the "-", the comparator sends out a "high". If the "-" input is even a little bit higher than the "+", the comparator sends out a "low". A comparator has only one threshold value. A Schmitt trigger can be built from a comparator and some resistors. Typically the circuit involves positive feedback -- attaching a resistor to feed a small amount of the comparator's output back to the "+" input. A Schmitt trigger has 2 threshold values.
A: Analogue and digital converters need a reference to weight the input related to the value of the reference. Other applications includes comparator switching and instrumentation
A COMPARATOR CIRCUIT WHICH CONVERTS ANY ARBITRARY SIGNAL(SLOPE!=1) TO SQUARE WAVEFORM IN SHORT A AMPLITUDE COMPARATOR
The Java superclass Object says that all Java objects have an equals method. Thus Comparator has an equals method.