Though not always marked as such, the popping crease (a line extending four feet in front of and parallel to the Bowling crease where the wicket is positioned) extends in both directions to the edges of the field.
the Crease
There are no instruction only crease pattern
they both show in crease but a line graph may show decrease
When you fold a paper in half, the line that runs down the center is called the crease.
Easiest way is to make a cut out of the image and determine if it folds in half. The crease made by folding in half is the line of symmetry.
You have to take guard at the popping crease for cricket.
Popping crease is a term that was used in the game cricket in the past. Popping crease was when batmen would have to pop their bat into a hole located in the middle of a crease to get a run.
1 metre
In cricket's rule number 9(specified by Marleybone Cricket Club or the MCC),the bowling crease,which is the line the stumps are in the middle of, is drawn at each end of the pitch so that the three stumps in the set of stumps at that end of the pitch fall on it (and consequently it is perpendicular to the imaginary line joining the centres of both middle stumps). Each bowling crease should be 8 feet 8 inches (2.64 m) in length, centred on the middle stump at each end, and each bowling crease terminates at one of the return creases. The popping crease, which determines whether a batsman is in his ground or not, and which is used in determining front-foot no balls (see law 24), is drawn at each end of the pitch in front of each of the two sets of stumps. The popping crease must be 4 feet (1.22 m) in front of and parallel to the bowling crease. Although it is considered to have unlimited length, the popping crease must be marked to at least 6 feet (1.83 metres) on either side of the imaginary line joining the centres of the middle stumps. The return creases, which are the lines a bowler must be within when making a delivery, are drawn on each side of each set of the stumps, along each sides of the pitch (so there are four return creases in all, one on either side of both sets of stumps). The return creases lie perpendicular to the popping crease and the bowling crease, 4 feet 4 inches (1.32 m) either side of and parallel to the imaginary line joining the centres of the two middle stumps. Each return crease terminates at one end at the popping crease but the other end is considered to be unlimited in length and must be marked to a minimum of 8 feet (2.44 m) from the popping crease.
A no ball
Four feet.
Popping crease and stumps is 1.22M or 4 feet
A return crease is drawn on each side of each set of the stumps, along each side of the pitch (so there are four return creases in all, one on either side of both sets of stumps). The return creases lie perpendicular to the popping crease and the bowling crease, 4 feet 4 inches (1.32 m) either side of and parallel to the imaginary line joining the centres of the two middle stumps. Each return crease terminates at one end at the popping crease but the other end is considered to be unlimited in length and must be marked to a minimum of 8 feet (2.44 m) from the popping crease.The return creases are primarily used to determine whether the bowler has bowled a no ball. To avoid a no ball, some part of the bowler's back foot in the delivery stride must land within and not touching the return crease.
22 yards
It is approximately equal the length of your foot, if measured from the crease of your elbow to the crease of the wrist with your arm straight down
It is 4 feet 4 inches.
Front on bowling action is where the back leg is behind the popping crease and front leg is facing the batsman.