0
What is the maxium length of 5 inch greenfield used as a fixture whip without support?
The maximum length for a 5-inch Greenfield (flexible metal conduit) used as a fixture whip without support is typically 12 inches, according to the National Electrical Code (NEC). This means that if the whip exceeds this length, additional support must be provided to ensure safety and compliance with electrical regulations. Always check local codes and regulations, as they may vary.
What else can I help you with?
What is the maximum length of 0.5 inch greenfield used as a fixture whip without support?
The maximum length of a 0.5-inch greenfield used as a fixture whip without support typically depends on local electrical codes and regulations. Generally, it should not exceed 6 feet to ensure safety and stability. Always consult the National Electrical Code (NEC) or local building codes for specific requirements in your area.
How To FIND tHE perimeter without the length?
You cannot. You must know, or be able to derive, the length.
What length should be used for the 36 ft support?
i am going to say yards
How do you find the length of a cube without a calculator?
Use a ruler
A rectangle has a permeter of 60 cm. its length is 5 times greater than its with. what is its length?
25cm - without using a calculator !
What is the maximum length of 0.5 inch greenfield used as a fixture whip without support?
The maximum length of a 0.5-inch greenfield used as a fixture whip without support typically depends on local electrical codes and regulations. Generally, it should not exceed 6 feet to ensure safety and stability. Always consult the National Electrical Code (NEC) or local building codes for specific requirements in your area.
What is the recommended length for a light fixture cord to ensure safety and proper installation?
The recommended length for a light fixture cord is typically around 6 to 8 feet to ensure safety and proper installation.
Will a T8 bulb fit in a fixture designed for T12 bulbs?
Yes, a T8 bulb can fit in a fixture designed for T12 bulbs as long as the wattage and length of the T8 bulb are compatible with the fixture.
How many fixtures can1.5 inch pipe vent?
That would depend on the fixture units each fixture has and the developed length of the vent piping
What is usually regarded as the absolute maximum length a driveshaft should be without adding a center support bearing?
70 inches is usually regarded as the absolute maximum length a driveshaft should be without adding a center support bearing
How do you plan out fixture drain venting?
By developed length and the amount of fixture units attached (1 FU =7.48 gallons) 1 cu ft
What size pipes are needed for vent pipes?
It depends on the developed length and fixture units.
How do you calulate the length of galvanized pipe?
By developed length of piping and fittings for venting and fixture units connected to it for water supply or drainage
How do you cap a garbage disposal that you have disconnected a dishwasher from?
Fit a short length of capped hose to the disoposal fixture.
How do you determine if the drain size is 4 or 3?
By the fixture units connected and the developed length of piping and fitting
What is the unsupported length of the column?
Length over which the column has no support is taken as unsupported length of the column
How far can the vent for the tub be away from the main sewer vent?
Up to 20,000 feet the fixture units and developed length are not exceeded.the key is to make sure the vent (even over 20,000 lineal feet) is pitched UP from the fixture being served so any condensation will flow back to the drain being servedEven with a very long run (20,000 PLUS) there should be no problems associated as long as the fixture units are below max allowed for the developed length of piping and fitting losses
