0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the turning point of a line?
An angle
What is the purpose of measuring taper angle of a taper plug gauge?
The purpose of measuring taper angle is to obtain taper angle
What A zero angle is an angle whose sides make a?
A single ray.
How many endpoints does a angle have?
An angle has two endpoints and a single vertex.
Why does a single angle of a pentagon equals 216 degrees?
A single angle of a pentagon can have any value between 0 and 360 degrees.
What is clearance angle of tool in lathe?
γ Back-off angle or clearance angle L w Length of the workpiece (not shown.
What is the turning point of a line?
An angle
What is the purpose of measuring taper angle of a taper plug gauge?
The purpose of measuring taper angle is to obtain taper angle
Explain the technical terms of a slip angle?
the angle relative to the wheel and chassis turning around corners
What A zero angle is an angle whose sides make a?
A single ray.
How many endpoints does a angle have?
An angle has two endpoints and a single vertex.
Can a congruent angle add up to 90?
A single angle can only add up to its own value! And how can a single angle be congruent? There have to be at least two angles for them to be congruent (or not).
Why does a single angle of a pentagon equals 216 degrees?
A single angle of a pentagon can have any value between 0 and 360 degrees.
What is the shape on an single angle?
The shape depends on the angle. Need more information.
Set a tool in a metal lathe at what angle?
Cutting tools for facing and outside diameter turning are set to an angle of 90 degrees to the bed. Boring tools are set to the same angle as the bed. Cutting tool tips are already angled to suit its purpose and there's usually no need for further adjustment. They can be set against the inside of the toolpost and fastened.
What is the purpose of the worm gear?
To tramsmit power at a 90 degree angle from the input.
How do you angle a picture on pages?
You angle a picture on pages by turning it a little bit but not to much or you will get a obtuse angle and make sure you use a ruler or something straight to balance it.
