Well, in my opinion, most French people are very bent, and believe me, they're no angels, these angels are known as the under bent angels, meaning that they bend under their offspring for a drink.
Mexicans, however, are over bent angels. The bend over their offspring for a spanking, this is how they get sexual stimulation.
One angle must be over 90 degrees (an obtuse angle), and the other two angles under 90 degrees (acute angles). ^-^
From 1933 to the end of WW2 in Europe.
No, it has two angles over 90 degrees and two angles below 90 degrees.
All angles between 180 and 360 degrees are reflex angles.
More- each angle is over 90 degrees.
The Bent Pyramids' angles were calculated incorrectly and would be too heavy for its' height. By the time this was realized, they changed the angles at the top to make the sides meet.
acute angles are angles under 45 degrees obtuse angle are angles over 45 degrees and right angles are ONLY 45 degrees
Typically, "bent" is used as an insult as in "get bent." The phrase "get bent" means "get bent over," in other words, "screw you."
One angle must be over 90 degrees (an obtuse angle), and the other two angles under 90 degrees (acute angles). ^-^
From 1933 to the end of WW2 in Europe.
the girl bent over to pick up her pencail that dropped
Planes can't bend over.
Waist slab is used in case of stairs. The rebars are bent at some angles on which steps are built.
If 1 or 2 of the obtuse angles are 'bent into' the hexagon then you can do it.A hexagon has 720° sum of interior angles. If you have 2 right angles, then that's 180°, leaving 540° to be distributed over four angles. If the two acute angles are 89°, then that leaves 362° to be divided between two angles, so at least one of these two angles will need to be greater than 180°. Below is my text graphics attempt of one possibility (ignore the 'dot'). Note that both of the obtuse angles are greater than 180°:|\_/||__.|Look at the related link to play with different angle possibilities for polygons.
The flag had a swastika which was an equilateral cross with its arms bent at right angles .
a bent control arm will change alignment angles. This can result in poor tire wear, a pulling to one side, tire rubbing on wheel well, etc... Basically its not good and not safe, get it replaced
He humped her