boring
Rigth line
Datum dimensioning is where a single reference point is used for all dimensions in a single direction. E.g. If Point A is declared the reference point, then Points B, C, D, etc, will all be measured relative to Point A, not to each other. Chain dimensioning is where each point is measured to the next. E.g. Point B is measured from Point A, Point C is measured from Point B, Point C is measured from Point B, and so on. The problem with chain dimensioning is that each measurement relies on the accuracy of the previous measurement. If there is a tolerance associated with each measurement (+/- X), then the tolerance for each subsequent dimension accumulates and becomes the number of measurements times the tolerance of each measurement (+/- n*X). Since datum dimensioning uses only one reference point, the tolerances cannot accumulate as each measurement is isolated, rather than relying on the accuracy of the previous measurement. Common practice is to only use datum dimensioning in design drawings to ensure greater accuracy over the entire design without requiring tighter tolerances.
Multi dimensions Or more easy using both metric and inches to represent dimensions
To solve problems it is important that the dimensions of the answer are those that are input to the problem. In Engineering the dimensions of an item are important so that it withstands the loads it is subject to.
Undirectional
boring
Things like General Dimensioning and Auto Dimensioning
Tabular dimensioning
Dimensioning standards are standards on how to dimension a working drawing.
It show dimension of given dig. Ex. length meter etc. > chain dimensioning as opposed to datum dimensioning. chain dimensioning: 4 holes in line on a drawing, first hole position dimensioned from the edge, remainder dimensioned from the centre of the previous hole. datum dimensioning: all holes dimensioned from the edge. the cumulative tolerance build up on the chain dimensioning allows for greater overall tolerance build up.
It deals with plant part responding to stimulus towards undirectional stimulus
Things like General Dimensioning and Auto Dimensioning
Baseline dimensioning is a method of dimensioning in technical drawings where all dimensions are referenced from a single baseline, reducing the chance of errors due to accumulation of tolerances. It helps to maintain clarity and consistency in the layout of dimensions on a drawing.
What is the difference between the conventional method of dimensioning and the baseline method of dimension
they are used by showing where it is
18" o.a.