answersLogoWhite

0

That gun was made by Marlin for Sears, and those holes are not factory. Someone has drilled and tapped it for (probably) a Weaver side-mount base.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you replace engine mounts on a Dodge Grand Caravan 2005 and how many mounts are there?

It depends on the exact model to which you are referring. Earlier models had three engine mounts; later models used four. If you are not comfortable or familiar with changing engine mounts, your best bet is to see an authorized mechanic, who can do the work needed.


How much is a JC Higgins Shotgun worth?

There are more than a few J. C. Higgins marked shotguns and values vary by model. More information is needed in order to provide an answer.


Why is the spring brake chamber not a primary element?

The spring brake chamber is designed as a parking brake only. The service brake chamber is air operated which can be controlled more efficiently as needed.


Will the transmission for a 425 cadillac motor mount on a 472 cadillac motor?

modifcation of the mounts is likely needed


How should patients be prepared for a hyperbaric chamber?

No special preparation is needed to use a hyperbaric chamber other than educating patients about what to expect during treatment.


What are the qualifications needed to rent section 8 housing at Hawthorne Place Apartments in Independence MO?

Check with you local Housing Authority there.


How do you remove motor mounts on hummer H3?

To remove the motor mounts on a Hummer H3, first, ensure the vehicle is securely lifted and supported. Disconnect the battery and then remove any components obstructing access to the motor mounts, such as the air intake or exhaust components. Next, support the engine with a hoist or jack, then unbolt the motor mounts from both the engine and the frame. Finally, carefully lift the engine slightly to remove the mounts and replace them as needed.


How do you install motor mounts on a 2007 Cadillac STS?

To install motor mounts on a 2007 Cadillac STS, first, ensure the vehicle is securely lifted and supported. Remove any necessary components obstructing access to the mounts, such as the air intake or engine covers. Then, unbolt the old motor mounts from the engine and chassis, carefully lifting the engine slightly if needed. Finally, position the new mounts, secure them with bolts, and reassemble any removed components.


How many engine mounts does an 1996 acura 2.5 tl have?

2, a left and a right. No, an Acura 2.5 TL has four engine mounts. A left and a right hydraulic mount located in the engine compartment, at the middle of the engine and two more mounts under the car bolted to the front of the transmission. The last two should really be called transmission mounts but they are listed and sold as motor mounts. The two front mounts cost at least $350.00 EACH!! The other mounts cost at least $50.00 each. I have worked on a few of these cars and every one had bad front hydraulic mounts. Some had all four mounts that needed to be replaced. Honda/Acura not as good as many of the other cars including domestic.


Will Honda civic engine fit on motor mounts on geo prism?

No, custom fabrication is needed. Get a civic if you want drop ins.


Can you use a 30 caliber on a g-3 rifle?

The G3 rifle can chamber the 7.62x51 NATO cartridge, and it could chamber the .308 Winchester if it needed to. No other cartridges are compatible with this rifle.


What were the common inovation after World War 2?

A common innovation after WWII was housing developments (tract housing); following the war, thousands and thousands of families were formed and needed inexpensive housing. The housing developments lead to strip malls, which lead to shopping centers.