Vertical angles occur when 2 angles are directly across from each other and are congruent.
Equal opposite vertical angles are created
The greater the vertical hierarchy the poorer the channels of commuication due the time process involved. Yet compared to flater hierarchys the structure is highly defined and therefore makes some processes more effective. eg. discipline and grievances
There is no such thing as exactly vertical because either it is vertical or it is not. You cannot have approximately vertical - it is not vertical, then. Vertical means at 90 degrees to the horizon (or horizontal).
In the case of a cuboid it makes little difference. In other cases, vertical, because many maths books refer to one of the non-rectangular sides as the "base" and a base should be at the bottom.
Looking at the instruction sheet of the unit, I would say that the vertical / horizontal position makes no difference in its operation. It looks like wire is wrapped around the pipe to form a DC coil and it is the flux from this coil is what penetrates the pipe. So again the coil does not know what position it is in, so should work in any position.
You can determine the direction of the torque acting on a coil by applying the right-hand rule. Point your thumb in the direction of the current flow, and curl your fingers in the direction of the magnetic field. The direction in which your fingers curl represents the direction of the torque (clockwise or counterclockwise).
When the coil is parallel to magnetic field, torque is maximum. When the coil is in vertical position, the torque is minimum. You can't go beyond that.
coil makes enough juice ( Amp) to spark the spark plugs. A faulty spark plug stops the coil to empty all the juices it has made and this makes the coil itself goes bad.
overshoot and stability
a vertical line is a line which is made from top to bottom or bottom to top.
An overshoot in action potential occurs due to the rapid influx of sodium ions causing the membrane potential to become more positive than the resting potential. This depolarization phase is necessary for propagating the action potential along the neuron.
The past tense is overshot.
Coil or powerpak. Test coil first.
due to commutation the current in the coil reverses
Peak overshoot in control systems refers to the maximum amount by which a system's response exceeds its steady-state value during a transient response. It is expressed as a percentage of the steady-state value. Peak overshoot is an important parameter as it indicates the system's stability and performance.
A cold anticipator