The extended side goes in the block.
thermostat is located inside thermostat housing, this is where the top radiator hose connects to engine
Just follow the large black hose coming from the top/side of the radiator to were it meets the block. The thermostat is located under the black hose engin side.Remove the clap and twist/pull off hose." note drain rad coolent level below the height of thermostat."
The Jiggle pin allowes any trapped air behind the thermostat to pass through. Without this the engine could overheat. The thermostat uses engin coolant to melt a wax capsule and allow coolant to pass. The engin could be at operating temp and the thermostat would not open due to air being in contact with the capsule instead of the actual coolent. This would most likely lead to an overheating engin, and damage.
thermostat should be in a plastic pipe mounted on the engin. to find this pipe just follow big pipe from radiator to engin. plastic pipe should be some where near the alternator
where is the engin block heater on a 2007 Ion
throat on back of water pump 2 bolts
The water pump forces the coolant to move through the water jackets after the thermostat is open to the manufacturer to the temp. spec. After the thermostat is open the coolant flows through the radiator to help control the cooling. When you turn on the heater the hot water flows through the heater core and back in the return line to the engin block.
the 360 l.a. engin came fatory with a 4" bore
Depending on your thermostat between 185 and 210 degrees
It is at the end of your top radiator hose where it clamps onto a housing on the engine. It is under that housing.
ouch, to get water on plugs the engine either has a cracked head or a cracked block
Engin Akyurek is a/an Actor