1. A paper towel 2. A can
Pi * r-squared * hAnswerAnd if your cylinder is not a right circular one, things get a bit tricky from there. =)
Drums, silos, CDs (they do have a height) are some examples.
When you calculate the volume of pipe(or cylinder, as I prefer calling it), you need to know 2 things; the height of the cylinder and the radius of the circle(base of the cylinder). Then you use this formula; hpr^2 (height * pi * radius)
A cylinder? A cylinder is still a cylinder regardless of how long it is.
A cylinder and a cone are 2 different things, so no.
You should notice a couple of things on purchasing an hydraulic cylinder, Bore Diameter: The diameter of the cylinder bore. Maximum operating pressure: The lowest working pressure is referred to as max. Operating pressure. Rod Diameter: Piston Diameter Type of Cylinder: Types of cylinder are ram cylinder, tie-rod cylinder and welded cylinder. Stroke: The travel distance of a cylinder is referred as stroke.
in
IT is called a cylinder
1. A paper towel 2. A can
the most accurate would be a graduated cylinder but there are beakers and other things that aren't as accurate
Pi * r-squared * hAnswerAnd if your cylinder is not a right circular one, things get a bit tricky from there. =)
Drums, silos, CDs (they do have a height) are some examples.
I don't know about the blue and gray plastic things, but the ignition lock cylinder must have the key in the on (run) position in order to get it to release in order to remove it, and the same on (run) position to install the lock cylinder.
worn rings , low compression , cylinder bore taper, cracked pistons , cracked cylinder heads between head gaskets, could be many things causing oil to many things breather
When you calculate the volume of pipe(or cylinder, as I prefer calling it), you need to know 2 things; the height of the cylinder and the radius of the circle(base of the cylinder). Then you use this formula; hpr^2 (height * pi * radius)
because people like big high round things......