680 was designed for straight walled rifle cartridges like the 30 carbine and the 33 hornet, can also be used in the 357 maximum for silhouette shooting.
Common sources include the loading manuals from Speer, Lyman, Hornaday Loading manuals for companies like Speer and Hornady are only going to give you load data for THEIR bullets--not Remington bullets. I haven't checked Lyman yet but the load data published by powder manufacturers are typically going to list loads using bullets manufactured by the major bullet companies. I am looking for a source that publishes loads using Remington bullets myself. No, you can't simply substitute a load using a bullet of the same weight as the Remington bullet you want to use. Bullet composition and design impacts CUP's.
It is not. Different people have different preferences for the way in which they can take in data. I'll take a well designed table over a stem and leaf any day.
It would be difficult to extrapolate data from a dot plot graph because dot plots are primarily used for displaying and comparing individual data points, rather than showing trends or patterns in the data. Since dot plots do not typically include lines or curves to connect the data points, it can be challenging to accurately estimate values between the plotted points or beyond the range of the data provided. Additionally, dot plots are not designed for precise numerical analysis or prediction, making it unreliable for extrapolating data.
It is probably a graph, of which there various types. All graphs are designed to show data in a visual form - bar graphs. line graphs, and so on.
Not exactly. A survey study is a study of some topic that involves collecting data using survey methods. Such research would need to be designed properly to be effective and efficient.
It was used for heavy field loads. 1 3/8 or 1 1/2. HS7 is kin to Winchester 571.May even be same powder.
Winchester 785 powder was designed as a slow burning powder for heavy bullets in magnum cases. It's burning rate is approximately the same as IMR-4831 and H-450. Data for IMR-4831 would be a good starting point if you cannot find original Winchester 785 Data. Some older manuals such as Hornadys third edition shows 785 data for most of the common calibers.
The last reloading manual I have that lists Winchester 450LS powder is the Speer number 8 manual published 1970.
http://www.accuratepowder.com/Default.htm
Yes, what powder are you using?
We can't answer for a couple of reasons. Winchester does not make 44 pistols. Any load data is based on exact caliber (there is more than one 44 caliber) the bullet weight and type, and the type of powder used (there are dozens of different powders)
The Lee table of dippers (available on their website) does not have a 5 cc dipper. It DOES have a 0.5 cc dipper (a lot of difference there, partner) It shows a charge of 5.4 grains of Winchester 231. Please exercise EXTREME care when seeking reload data on an open site, such as this one. For all you can tell, I am 10 hears old (I'm not, but YOU can't tell that) Please use the on-line data from manufacturers, such as Lee Precision, or powder company on line data.
Go to Proofhouse.com and look at the Winchester sn data.
Proofhouse.com has Winchester sn data.
If you were to go to hodgdon,s web site there is a site entitled load data.Just pick the caliber first,then the bullet weight,then the powder maker,the site will show you the starting load in grains for the powder you choose and the max powder charge in grains also.Good luck!
Proofhouse.com has Winchester sn data you can look up.
Go to Proofhouse.com and look at the Winchester sn data.