0
When letting bleach sit for 10 minutes does it disinfect?
CheenaCruz
Yes it does.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How many minutes of lecture can you sit through on the energy supplied by 32 grams of peanut?
That completely depends on the levels of consciousness, attention, involvement, and interest you maintain as you 'sit through' the presentation.
Is sit an adjective?
No, sit is a verb
How should you invest my inheritance of one hundred thousand dollars and not lose any money?
I would invest the money as a CD or in a money market account at your bank. These kinds of accounts usually have high interest rates, so you actually gain money while letting it sit in the bank.
What are 10 words that mean sit?
sit
How many syllables are in the word sit?
The word sit has one syllable.
What would be the best concentration of bleach to use to disinfect kennels at a vet clinic?
10% (v/v) sodium hydroxide (bleach) will destroy most bacteria and viruses. Let the bleach sit on the surfaces at least five minutes, then rinse well with clean water until you can't smell the bleach at all. Let the kennels dry out for 15 minutes, then you can use them again.
How do you bleach Converse?
To bleach Converse shoes, mix equal parts bleach and water in a well-ventilated area. Use a brush or sponge to apply the bleach solution to the canvas in a sweeping motion. Let the bleach sit for a few minutes before rinsing the shoes with water and letting them air dry.
How long does Reds last?
A little over 20 minutes. It depends if your chewing on it or letting it sit there though
How long does BIG Red last?
A little over 20 minutes. It depends if your chewing on it or letting it sit there though
How many drops of bleach to purify a gallon of water?
To purify a gallon of water, you can use 8 drops of bleach if the bleach concentration is 8.25%. Mix well and let it sit for at least 30 minutes before consumption.
How much chlorine do you need to mix a solution in a 15 ounce spray bottle of water?
To disinfect water in a spray bottle, you typically need around 2 to 3 drops of bleach per quart of water or 4 to 6 drops per liter. For a 15-ounce bottle (which is approximately 450 ml), you would need about 6 to 9 drops of bleach. Make sure to use unscented bleach and let the solution sit for at least 30 minutes before use.
How do you disinfect carpets?
To disinfect carpets, first vacuum to remove dirt and debris. Then, use a carpet disinfectant spray or solution, following the manufacturer's instructions. Allow the disinfectant to sit on the carpet for the recommended time before vacuuming or drying.
Products needed to clean a mouse cage?
My kids have Bearded Dragons, (Reptiles) and we use a Solution of 10 percent Bleach to water. This will disinfect the surfaces without using too many harsh chemicals that you cannot get rinsed off. Just let it sit for at least 10 minutes with the solution on the surface and then rinse well, that will give the bleach time to work good. I just put it in a spray bottle like you can pick up in any dollar store. Just see how many ounces the bottle will hold and divide by 10, use that answer for your ammount of bleach and fill the rest of the way with water.
Can bleach be used to purify water?
Yes, bleach can be used to purify water by killing bacteria and viruses. The general guideline is to add 8 drops of bleach per gallon of water, stir, and let it sit for 30 minutes before using. It is important to use unscented bleach and follow the correct dosage to ensure safe drinking water.
Will disconnecting the battery on a passat and letting it sit restart?
No it will not restart
What is the technical name for letting a roast sit after cooking?
Resting
How do you clean a camelback backpack water system?
2 tablespoons of bleach in a gallon of water. Open the bladder and drop everything into the bucket of bleach water. Make sure the water touches everything. Fill the bladder, cap it, then squeeze the bleach water through the bite valve. Let it sit at least 30 minutes before rinsing it out.
