www.engineeringtoolbox.com/viscosity-converter-d_413.html
Infinite shear viscosity refers to the viscosity of a fluid measured at very high shear rates, where the flow behavior becomes independent of the rate of shear applied. In this regime, the fluid's resistance to flow stabilizes, allowing for a consistent measurement of its viscosity. This concept is particularly relevant in materials that exhibit non-Newtonian behavior, where viscosity can change based on the shear rate. Infinite shear viscosity is critical in understanding the flow behavior of complex fluids such as polymers and suspensions.
Any fluid is an emaple of viscosity.
The absolute viscosity is 1.2 at 31%
viscometer
The K value of PVC resin is calculated using the Fikentscher K value equation, which is K = (135.5 - 0.31 * log(viscosity)) * (1 - 0.008 * (log(viscosity) - 1)), where viscosity is the intrinsic viscosity of the PVC resin solution. In practice, the viscosity is typically measured using an Ubbelohde viscometer or an Ostwald viscometer. The K value is an important parameter that indicates the average molecular weight of the PVC resin and is used to classify different grades of PVC based on their properties and applications.
centistokes (cSt)
The kinematic viscosity of water at 74 degrees Fahrenheit is approximately 1.042 centistokes.
Centipoise divided by specific gravity is equal to centistokes. Centipoise divided by specific gravity is equal to centistokes. Centipoise divided by specific gravity is equal to centistokes. Centipoise divided by specific gravity is equal to centistokes.
There is no direct conversion between Saybolt seconds and centistokes because they measure different properties of fluids (viscosity vs. flow time). Saybolt seconds measure the time it takes for a volume of fluid to flow through a specific orifice, while centistokes measure the dynamic viscosity of a fluid. You would need additional information or testing to convert between the two units.
See link: http://www.engineeringtoolbox.com/water-dynamic-kinematic-viscosity-d_596.html
SAE 10 and ISO 46 are not the same, but they are related. SAE 10 refers to a viscosity grade in the Society of Automotive Engineers (SAE) classification system, typically indicating a viscosity of around 10 centistokes at 100°C. ISO 46, from the International Organization for Standardization, indicates a viscosity of approximately 46 centistokes at 40°C. While both are used to describe oil viscosity, they apply to different temperature ranges and measurement standards.
The viscosity of honey is typically around 2000-10000 centipoises at room temperature, which is much higher than that of water. Honey's viscosity can vary depending on its temperature and moisture content.
The viscosity of Low Sulfur Diesel Oil (LSDO) typically ranges from 1.5 to 4.1 centistokes at 40°C. It is important to check the specific product specifications from the manufacturer to get the exact viscosity value.
Vinegar has a low viscosity. Vinegar is 1.35 CentiStokes. While water is 1.00 but vinegar still has a low viscosity.
The kinematic viscosity of water at 20°C is approximately 1.0036 centistokes. This value can vary slightly depending on the exact temperature and pressure conditions.
The viscosity of No. 2 diesel fuel at -20°F is typically around 4.0-6.0 cSt (centistokes). However, it's important to note that the exact viscosity can vary depending on the specific blend and composition of the diesel fuel.
The viscosity of Diesel 2 at 37.8 degrees Centigrade is 2 to 6 centistokes. This is equivalent to 32.6 to 45.5 SSU.