Hold mode button until alarm time appears push mode button one more time until seconds flash on current time click adjust button to switch between minutes and hours click alarm button to change hour or minute. Click mode to exit "set" mode
Press the MODE button 3 times. Press the LAP/RESET button until the hour flashes. Press the ST./STOP button to change the hour. Press the LAP/RESET button again to select the minutes. Press the ST./STOP button to change the minutes. Press MODE again when you're finished setting the time.
you go to alm1 or 2 and keep the reset button pushed in till number flashes then use st stp button to set and to change digits press mode button
Use the float feature found on the mode button. Press mode and then select a number next to FLOAT. If FLOAT is selected, the calculator will not round. Selecting a number next to float will round to that many decimal places.
Haier does not typically offer remote codes but I was able to find some that do work to some degree for my LED flat screen model LEC32B1380. 681, 684 provides power on/off. 738 provides power plus volume. Use the following process to find codes for your TV if the above do not work for you. Power scan instructions: Step 1: Press and hold the TV mode button until all mode button back lights illuminate, then release. Step 2: Press and release the Power button. Step 3: Press the Up button once a second while pointing the remote at the desired equipment. If the code for the equipment comes up, the equipment will poweroff. Step 4: Press the pound (#) button. If the code entered is valid for the remote, the mode light flashes three times. After doing the power scan please remember to put the remote back into SAT mode. Cheers!
it is the home button dude:)
The am\fm running is to the left of the volume button when you are in tuner mode.
hold down the "MODE" button on the right. you will notice the power symbol above the mode button.
hold down the "MODE" button on the right. you will notice the power symbol above the mode button.
Hold mode button until alarm time appears push mode button one more time until seconds flash on current time click adjust button to switch between minutes and hours click alarm button to change hour or minute. Click mode to exit "set" mode
No it sends you to the home screen
what button on PSP skips the initial setup
Mode refers to the current set of functions. For example, on a digital watch, in time-setting mode, a specific button will change the hour; change the watch to stop-watch mode and that button might start the timing.
there is no such button
first you have to change the mode with the mode button. then you chose time, seconds, or minutes with the start button. You change the time with the light button. Good luck.
hold down the mode button for about 3 seconds.
Push the tow mode button