abc
10
cat5
the answer is 3
Fabric, Cable, Wire, Rope
0.1 of a nautical mile 185.2m
coaxial
Ethernet
The longest Xbox 360 Ethernet cable you can use is typically 100 feet (30 meters). Using a cable longer than this can result in a loss of signal quality and slower connection speeds. It's best to keep the cable length as short as possible for optimal performance.
If the cable gets long enough, yes.But the two most common Ethernet standards (100 Mbps and Gigabit) state a maximum cable length of 100 meters, so you are not likely to run into this limitation for household use.See related Wikipedia link.
The ethernet helps you surf the internet faster
A PS3 has WiFi and you can put the router next to your modem. The only thing the back of a PS3 uses for the internet is for a wired connection with an ethernet cable to your router or modem instead of a WiFi connection
Ethernet cables are made from cat5e cable. This cable is designed for carrying signals and is commonly used in networking. It is made up of several multicolored wires which carry the signal. This cable must have Ethernet Connectors on both end to enable to to be plugged into a router or modem.
100 meters. Which is 324 feet.
The Cable Cat 6 is an Ethernet cable that supports fast Ethernet 10G BASE-T. This cable is available in a 20 meter length online from various retailers including cabling4less.
longest i have seen in a store was 100ft but if you need longer get a roll of Ethernet cable and 3 ends for it then make your own length of cable.
The standard Ethernet cables (UTP) basically limits the maximum distance between hubs, or between switches, or between a hub and a switch, to about 100 meters. If you use a longer cable than that, the signal will degrade too much, and the network may become unstable.The standard Ethernet cables (UTP) basically limits the maximum distance between hubs, or between switches, or between a hub and a switch, to about 100 meters. If you use a longer cable than that, the signal will degrade too much, and the network may become unstable.The standard Ethernet cables (UTP) basically limits the maximum distance between hubs, or between switches, or between a hub and a switch, to about 100 meters. If you use a longer cable than that, the signal will degrade too much, and the network may become unstable.The standard Ethernet cables (UTP) basically limits the maximum distance between hubs, or between switches, or between a hub and a switch, to about 100 meters. If you use a longer cable than that, the signal will degrade too much, and the network may become unstable.
The maximum distance of 100BaseT, also known as Fast Ethernet, is 100 meters using twisted-pair cable. Beyond this distance, signal degradation can occur, affecting network performance.