No. The diagonal through a rectangle can be computed via the Pythagorean theorem: c2 = a2 + b2 where c is the diagonal length and a and b are the horizontal and vertical lengths of the rectangle.
Actually, a rectangle has four lines of symmetry:One horizontal;One vertical; andTwo diagonal.
It is a rectangle which is similar to the base.
A horizontal line.A horizontal line.A horizontal line.A horizontal line.
a rectangle in the middle, 4 squares surrounding it then attached to one of the horizontal sides, another rectangle which is also horizontal.
No. The diagonal through a rectangle can be computed via the Pythagorean theorem: c2 = a2 + b2 where c is the diagonal length and a and b are the horizontal and vertical lengths of the rectangle.
Actually, a rectangle has four lines of symmetry:One horizontal;One vertical; andTwo diagonal.
Cylinder
If the cylinder is standing on its flat face, the horizontal cross section is a circle. Otherwise, it is a line or a rectangle.
draw a rectangleput one line top to bottom strait down the middledraw a horizontal line across in the middle
It is a rectangle which is similar to the base.
A horizontal line.A horizontal line.A horizontal line.A horizontal line.
A rectangle is a possible candidate, as is an ellipse.
A rectangle minus a smaller rectangle which share a vertex.
a rectangle in the middle, 4 squares surrounding it then attached to one of the horizontal sides, another rectangle which is also horizontal.
It is made up out of 4 lines, 4 corners and 4 right angles. Haha, this is all I can say on how to make a rectangle. Draw a horizontal line along the page (say 5 cm long) Using a pair of compasses and a straight edge construct a 90o angle at the left end of this line; or alternatively measure 90o using a protractor at the left end. Draw another line from the left end vertically up this 90o angle (say 2 cm). Using a pair of compasses set to the length of the long horizontal line, put the point at the top of the vertical line and draw an arc over the right end of the horizontal line (roughly the height of the vertical line above it) Now setting them to the length of the vertical line, put the point on the right end of the horizontal line and draw an arc to intersect the previously drawn arc. With the straight edge, join the top of the left vertical line, and the right of the horizontal line, tot he point where the arcs cross. Rub out the arc construction lines and you'll have a rectangle left.
The horizontal change is the change in x. If the line in horizontal then the horizontal change will just be its length.