0
What else can I help you with?
Why it is important to correctly rate and select a cable for the application?
Unknown
A cable is 30 decimeters long How long is the cable in meters?
the answer is 3
In 1980 if there were 17.7 million households with cable and that was 28.5 percent of the households that had cable in 2000 then how many households had cable in 2000?
62,105,263 households.
How many feet are in one cable?
1 US cable equals 720 feet. 1 British cable equals 608 feet. A cable is a nautical unit of measure equal to one tenth of a nautical mile.
A cable is 90 decimeters long how long is the cable in meters?
9 meters
Why it is important to correctly rate and select a cable for the application?
Unknown
You can select the cable length in the option box.?
You can select the cable length in the option box.
What is the function of cable select jumper setting?
The function of cable select jumper setting is to let the cable select which drive takes priority ("master") and which one comes after ("slave").
How do you select a cable size?
according to use
Why is it important to correctley rate and select a cable for application?
cuz' stone cold said so!
What is the drive nearest motherboard when using an 80-conductor cable-select cable?
Master.
When using an 80-conductor cable-select cable the drive nearest the motherboard is the?
Answer: When using an 80-conductor cable-select cable, the drive nearest the motherboard is the master, and the drive farthest from the motherboard is the slave. You can recognize a cable-select cable by a small hole somewhere in the the data cable or by labels (master or slave) on the connectors. -CompTIA A+ Guide to Hardware, Managing, Maintaining, and Troubleshooting Fifth Edition 2010 copyright - Jean Andrews, Ph.D.
Can you use a router with cable Internet?
Yes you can. Just connect it to the cable box, and set it up correctly.
If your computer does not recognize the new floppy drive?
the cable is not inserted correctly
Why LED of FDD is Continuously glow?
This is a question from the A+ test!!!!!! The answer is that the cable is reversed at one end. The cable must be plugged in correctly at both the ends. The red wire on the cable shows the pin 1 end of the connector and must be plugged in correctly on the MB and the drive.
How do you disconnect a car battery correctly?
Always disconnect the negative cable first. When reconnecting always connect the positive cable first.
Which statement correctly characterizes cable types and their usage?
Fiber optic cable is primarily used for networking within a single building.
