i think not.
diodes have a low breakdown voltage, around 1v. a diac has bv of about 30v.
a diode is a device that alows current to flow in one direction you have power diodes which are used in rectification processes and high current operations but the two main families of diodes are solid state diodes or valve operated diodes.
As I have no information on the circuit I can make no valid predictions as to the effect of replacing diodes with resistors. However I assume the effect(s) will resemble that of having very defective diodes in the circuit.
Silicon "zener diodes" with a zener voltage rating of 5.6V or higher operate mainly by avalanche breakdown, so both the 6.2V and 24V "zener diodes" are avalanche breakdown type (not zener breakdown type).
Yes, if the transformer secondary is centertapped.
There are lots of diodes - a "diode" is simply a device that has two electrical connections.If you refer specifically to the rectifying diode, it is used to convert AC current to DC current - so, it is used in a circuit that has BOTH AC and DC.
A DIAC is a diode alternating current switch. Its construction consists of two back to back diodes. It is usually used for triggering TRIACS.
An antiparallel is a line which forms equal angles with two other lines but in opposite directions.
When it is not parallel. Parallel is when it is two straight lines: like train tracks are antiparallel, when it is going of course: Like a trapezium.
A DIAC operated with a DC voltage across it behaves exactly the same as a Shockley diode. With AC, however, the behavior is different from what one might expect. Because alternating current repeatedly reverses direction, DIACs will not stay latched longer than one-half cycle. If a DIAC becomes latched, it will continue to conduct current only as long as there is voltage available to push enough current in that direction. When the AC polarity reverses, as it must twice per cycle, the DIAC will drop out due to insufficient current, necessitating another breakover before it conducts again
The diac conducts in both directions at approximately the same voltage, making it unsuitable in an AC to DC supply. The triac also conducts in both directions, based on a gate voltage which is slightly different in the two usable quadrants. That is why the diac is often used to trigger the triac - it makes the two conduction cycles more symmetric. In both cases, the diac/triac does not make sense for an AC to DC supply, but it works well in an AC voltage regulator, such as a lamp dimmer or motor speed controller.
Anti-parallel means the sides of the DNA double helix.
a diode is a device that alows current to flow in one direction you have power diodes which are used in rectification processes and high current operations but the two main families of diodes are solid state diodes or valve operated diodes.
Because two diodes is not a transistor. There is an interaction between the junctions in the transistor, because of their proximity, that you don't get in the two diodes. The only use of modeling a transistor as two diodes back to back is to test a transistor with a multimeter as a quick go-nogo test for basic operability.
There are several types of diodes; the only thing they have in common is that they have two electrodes - hence the name.
Two types used at microwave frequencies are gunn and PIN diodes.
Lots of things are true about diodes. There are different types of diodes; their general characteristic is that they have two electrodes (electrical contacts). They conduct current in one direction only.
Anode and Cathode.