answersLogoWhite

0

measuring pool shock treamentif its 1lb for 12,000 gallons than half of that would be 1/2 lb for 6000 gallons. 1/4 lb. for 3000 gallons.

I would use a little less than 1/4 lb. of Shock.

Maybe get a 1/4lb. and separate it into 3 equal parts. Then just use 2 parts for your 2000gallons pool.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How much shock do you put in 2000 gallons of water?

The amount of shock needed for 2,000 gallons of water depends on the type of shock being used and the specific water conditions. For standard chlorine shock, a typical guideline is to add 1 pound of shock per 10,000 gallons of water. Therefore, for 2,000 gallons, you would use about 0.2 pounds (or roughly 3.2 ounces). Always follow the manufacturer's instructions for the best results.


How much shock and swim for 198 gallons?

To determine the amount of shock and swim for 198 gallons of water, a common recommendation is to use 1 pound of shock per 10,000 gallons for a standard dose. For swimming pools, you might add about 1-2 ounces of chlorine shock per 1,000 gallons, which translates to about 20-40 ounces for 198 gallons. Always refer to the specific product instructions for accurate dosing, as concentrations can vary.


How many gallons of chlorine in an olympic size pool?

Olympic swimming pools use about 650000 gallons of water, so if you're trying to shock one using 10% liquid chlorine, you would need about 200 gallons of liquid shock - or if you're only adding choline as a primary sanitizer, not as a shock, you'd use about 65 gallons.


If the shock says 1lb per 12000 gallon pool how many tablespoons for a 300 gallon spa?

It is 0.4 ounces.


Does the earth shake in the earthquake?

yes,the shock waves spread in all directions like when we throw a stone in a pool of water,as the shock waves goes further the power of the shock decreases


How much shock powder should you put in a 15ft by 42 pool?

To determine the appropriate amount of shock powder for a 15ft by 42in pool, you typically need about 1 pound of shock per 10,000 gallons of water. A pool of that size holds approximately 4,500 gallons. Therefore, you would use about 0.45 pounds (or approximately 7.2 ounces) of shock powder. Always refer to the specific product instructions for precise dosing, as concentrations can vary.


How do you change rear shock absorber?

Its not too hard to change them, see related link (pictures are gone, but directions remain).


How much chlorine bleach to add to 639 gal of pool water to shock water?

To shock a pool, the general recommendation is to add 1-3 gallons of chlorine bleach (5-6% concentration) per 10,000 gallons of water. For 639 gallons, you would typically add around 0.06 to 0.19 gallons, which is approximately 8 to 24 ounces. Always check the specific instructions on the bleach label and test the water afterward to ensure proper chlorine levels.


How long does a shock absorber last?

Years ago, they commonly lasted 25-30 thousand miles. Today's shock absorbers will commonly last 100,000 miles or more, but the companies that make shock absorbers still urge you to get them changed at 25,000 mile intervals - because they're in business to sell shock absorbers.


What amount of chlorine will shock a swimming pool?

an average dosage rating would be 1 pound of calcium hypochlorite per 10,000 gallons


How much chlorine granules for 2529 gallons of water?

one pound of cal hypo, granule chlorine, will treat 10,000 gallons of pool water. So use 1/4 pound to shock, two or three times that if pool goes green. If pool has a vinyl liner use sodium hypochloride, liquid shock, instead of granules.


How often are shock tablets used in 3800 gallons?

The frequency of using shock tablets in 3,800 gallons of water, such as in a swimming pool or spa, typically depends on factors like water usage, weather conditions, and the presence of contaminants. Generally, it's recommended to shock the water every 1-2 weeks, or more frequently after heavy use or rain. Always follow the manufacturer's guidelines for dosage and frequency to maintain optimal water quality.