To convert amps to watts in a 12-volt application, you can use the formula: Watts = Volts x Amps. Therefore, in a 12-volt circuit, if you have 1 amp of current, the power consumption would be 12 watts (12V x 1A).
Your 12 volt 2 amp battery charger draws 24 watts of power (12 volts x 2 amps = 24 watts).
The power output of a 12-volt battery producing 2.7 amps can be calculated using the formula: Power (watts) = Voltage (volts) x Current (amps). So, in this case, the power output would be 12 volts x 2.7 amps = 32.4 watts.
To find the amperage produced by a 170 watt, 12 volt solar panel, you can use the formula: Amps = Watts / Volts. In this case, 170 watts / 12 volts = 14.17 amps.
A 10 amp charge will only output 10 amps and 12 volts. So, if you want to charge thee 12 volt batteries hooked in series you will have to disconnect the positive cable from each battery and charge then individually. You cannot charge three 12 volt batteries hooked in series. That requires a 36 volt charger.
Depends on the battery. It is listed on the battery as Cold Cranking Amps (CCA).
55/12=4.6
To convert amps to watts in a 12-volt application, you can use the formula: Watts = Volts x Amps. Therefore, in a 12-volt circuit, if you have 1 amp of current, the power consumption would be 12 watts (12V x 1A).
0.5 amps
No you cannot house amps use 120 volt ac car amps use 12 volt dc
It takes between 8 and 12 hours to charge a 12 volt battery at 2 amps. The actual time will depending on how much charge is in the battery initially.
Yes
You would need to connect the two 12 volt batteries in series. That will give you 24 volts and the amps of one of the batteries. Voltage doubles and amps stay the same.
Your 12 volt 2 amp battery charger draws 24 watts of power (12 volts x 2 amps = 24 watts).
1 HP = 745.70 wattsPower (watts) = Current (amps) x VoltsSo if you use a 110 volt system, amps = 745.7/110 = 6.779 ampsIf you use a 220 volt system, amps = 745.7/220 = 3.389 ampsFor a 12 volt system, amps = 745.7/12 = 62.142 amps
It would be at least 250 amps, maybe 300 amps.
attach the neg to neg and pos to pos. this will keep 12v but increase the amps