Wiki User
∙ 12y agoThis is not a good idea. The washing machine current will surge when motor is started. a 20 Amp dedicated circuit is recommended for a washing machine.
Wiki User
∙ 12y agoIt is not recommended to piggyback additional outlets onto a dedicated circuit for a washing machine as it may lead to overloading the circuit and creating a fire hazard. Instead, consider running a new circuit for the additional outlets to ensure safety and proper functionality.
A 2C #14 will be suffice but it should be the only device on the circuit. This is known as a dedicated circuit.
A dedicated outlet is an electrical outlet that is reserved for a specific appliance or device. It is designed to supply power exclusively to that item, ensuring safe and reliable operation without overloading the circuit. Dedicated outlets are commonly found in kitchens for refrigerators and ovens, or in home offices for computers and printers.
This may happen if the washer machine and the light are connected to the same electrical circuit. When the washer machine turns on, it may cause a power surge that triggers a temporary voltage drop in the circuit, which can cause the lights to dim or flicker momentarily.
To reset a circuit breaker on a shop vac, first unplug the machine. Locate the circuit breaker on the power cord or the vacuum itself and press the reset button. If the breaker doesn't reset, check for any obstructions or issues with the vacuum that may be causing the problem.
The voltage would be the same even if you installed three washing machines. The amp draw is what will change. An automatic washer uses about 120 volts at about 700 watts, so your washer would draw a little less than six amps. It is recommended that it have a dedicated 20 amp circuit. If you install a dryer then the voltage requirement would be about 240.Rate
A 2C #14 will be suffice but it should be the only device on the circuit. This is known as a dedicated circuit.
A dedicated outlet is an electrical outlet that is reserved for a specific appliance or device. It is designed to supply power exclusively to that item, ensuring safe and reliable operation without overloading the circuit. Dedicated outlets are commonly found in kitchens for refrigerators and ovens, or in home offices for computers and printers.
Dedicated fax machine is the main fax machine that can be configured to where the fax will be receive and support extension fax machine.
You need a dedicated circuit for that. You cannot power a 220V device off 110V.
Can we ensure the same degree of security in a time-shared machine as we have in a dedicated machine?
ur penis or vagina.
extreme convenience leads to laziness
CCTV = Closed Circuit TV. It's a system, not a machine.
Because water is a conductor, and being fluid as it is, when spilled and falls into the machine, makes contact between or within a circuit that completes the circuit short.
Three phase uses a safety circuit away from the machine, two phases uses you as the safety circuit
You cannot connect directly unless the espresso machine specifies it can operate at the lower voltage. If the machine were to operate you would be doubling the current. If you installed a transformer or converter to up the voltage you would have to ensure that you didn't overload the 110 volt circuit. Best bet is to have an electrician install a dedicated 220 volt circuit.
Of course it can! Based on my research dedicated to your question, i found that the macintosh is a virtual technology machine!