The electrical code states for non vehicular area 18 inches, for vehicular area 24 inches. This is the minimum cover distance between the top surface of the conduit and the finished grade.
200 m. deep.
200 feet wide x 900 feet deep is 4.132 acres.
Each phase conductor on a 200 amp residential service typically carries up to 200 amps of current, assuming the load is evenly distributed across all three phases. Each phase conductor should be able to handle the maximum current capacity of the service to ensure safety and proper functioning of the electrical system.
For a 200 amp service, it is recommended to use at least a 3/0 copper or 4/0 aluminum wire. These wire sizes can safely handle the current and provide necessary voltage drop considerations for a 200 amp service.
In a 200 amp service, each leg carries 100 amps. However, since the legs are 180 degrees out of phase, you can achieve 240 volts across both legs. So, a 200 amp service typically consists of two 120 volt legs, each providing up to 100 amps.
For a 200 amp service, a minimum of 2/0 gauge aluminum wire should be used.
Answer: 200 meters deep = 656.167 feet deep.
it is about 200 feet deep.
656.167 feet deep
200 m. deep.
Copper wire is recommended for a 200 amp service due to its higher conductivity and lower resistance compared to aluminum wire.
For a 200 amp service, it is recommended to use aluminum wire that is at least 4/0 gauge in size to ensure proper conductivity and safety.
For a 200 amp service installation, it is recommended to use copper wire with a gauge size of 2/0 or larger to ensure proper electrical conductivity and safety.
200 feet
About 200 feet.
It would be 2,178 feet deep x 200 feet wide.
200 feet wide x 900 feet deep is 4.132 acres.