you need to make sure that the mrks line up, but the ecu, will adjust timing and whatnot to an extent, but only within a few degrees. if you have a shop book this will explain more thoroughly, i dont have mine handy, but it is in there.
To time a 1991 Ford Ranger 2.3L, you will need a timing light. Start by locating the timing marks on the crankshaft pulley and timing cover. Connect the timing light to the battery and number one spark plug wire, then aim the light at the timing marks while the engine is running. Adjust the timing by loosening the distributor and rotating it until the timing mark lines up with the specified degree on the timing cover.
There are approximately 1959.42 ounces in 58 liters and approximately 777.88 ounces in 23 liters.
To change the fuel pump on a 1994 Mercury Topaz, you will need to access the fuel tank by lowering it from the vehicle. Disconnect the fuel lines and electrical connections, then remove the old fuel pump from the tank. Install the new fuel pump and reassemble everything carefully. Be sure to refer to your vehicle's service manual for specific instructions.
egr valve location on a 1997 ford ranger 23l
Take it to jasper they rebuild any motor.
yes
they stems from the intake manafold then run in several places
The engine oil capacity for the 1992 2.3L is 5 quarts (includes filter).
Here you go: Copy & paste into your browser: http://autorepair.about.com/library/firing_orders/bl-fo-7923.htm
i called the ford dealership they recominded that u not do it yoursealf unless you had a full shop worth of equipment i have a 93 ford ranger 2.3L 5speed and i had it done by a local mechanic for 300 i bout the parts myself it was worth it..
Here you go: Copy & paste into your browser: http://autorepair.about.com/library/firing_orders/bl-fo-7923.htm
bad crank shaft position sensor
On my 1993 Ranger, 2.3L, it is a bolt between the two front wheels underneth the engine. Should be pretty easy to spot. The oil filter is on the drivers side of the engine, towards the bottom. Also easy to spot.
23L 4cylinder motors dont have distributors the cylinders on the block are numbered (front to back) 1234 and the firing order is 1-3-2-4 Correct Firing Order: Correct firing order is 1-3-4-2; Haynes Manual #36071, 1993-2005 Ford Ranger Pick-ups
The PCV is located on the driver's side of the engine. It is at the same level as the spark plugs, in the middle of the engine. It is not seated in the oil cover. It is seated in the oil diverter.