0
Answer for USA, Canada and countries running a 60 Hz supply service.
If your circuit is 120v, you can put 38 50W lights on a 20 amp circuit. I know that sounds like a lot, but these 38 lights will draw just under 16 amps which is within code requirements.
<><><>
As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.
Before you do any work yourself,
on electrical circuits, equipment or appliances,
always use a test meter to ensure the circuit is, in fact, de-energized.
IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOB
SAFELY AND COMPETENTLY
REFER THIS WORK TO QUALIFIED PROFESSIONALS.
What else can I help you with?
What is an off hook circuit?
An off-hook circuit refers to the state in which a telephone handset is lifted from its cradle, indicating that the line is engaged in a call. When the handset is off-hook, the circuit is closed, allowing communication to take place.
Can you hook a 200 watt amplifier to a 120 watt sub woofer?
Yes it should be all right. Ratings for amp/speakers are approximate but as a rule it is preferable for the speaker to be rated higher than the amp.
How do you hook up a 40 amp breaker panel?
To hook up a 40 amp breaker panel, first turn off the main power source. Then, connect the wires from the circuit breaker to the panel's bus bar, making sure to follow the manufacturer's instructions. Lastly, turn the main power back on and test the circuit to ensure it is working properly.
How many lights can you hook up on a 600amp low voltage?
If the voltage is right for the bulbs, you can hook up 600 amps divded by the amps taken by one bulb - that gives the number of bulbs. But 600 amp needs very thick wire.
How do you hook up 12 volt lights to a 36 volt battery system?
To hook up 12 volt lights to a 36 volt battery system, you will need to use a voltage regulator to step down the voltage from 36 volts to 12 volts. This regulator will ensure that the lights receive the correct voltage to operate without being damaged by the higher voltage of the battery system. Be sure to consult an electrician or someone with experience in electrical work to ensure a safe and proper installation.
How can you build a computer controlled musical Christmas lights display?
To build a computer controlled musical Christmas lights display, you need to hook up your computer to a micro-controller, that is attached to the circuit of lights. For simplicity, Arduino is recommended for building this display.
How do you hook up an vr3 200 watt 2 channel amp to a car stereo?
well you hook it up
How do you test car wiring using a powered circuit tester?
hook the ground wire to a good ground and pierce the wire you want to check with the tester, if it lights up, it has power, if not it doesnt.
How do you hook up led lights to turn on when you turn the light on in a car?
you hook it in the trunk
What is the best way to hook up a single 12 inch dvc to a 1200 watt amp?
The best way to hook up a single 12 inch dvc to a 1200 watt amp is to use an MTX thunder box.
How do you hook up a pioneer DEH-730?
CIRCUIT
Circuit city's slogan?
We'll hook you up
How can it be detemined if an element can conduct electricity?
Turn a bit of it into a wire and hook it up in a simple circuit with a lightbulb and a battery. If the lightbulb lights up, it's a conductor. If the lightbulb stays dark it's not.
Why is there a 1991 trailer lights hook-up?
test
How are the lights attached to side purlins?
hook-and-loop
What if you have an orange wire left and nothing to hook it on to?
hook it to the other orange it controls ur dash lights
What is an off hook circuit?
An off-hook circuit refers to the state in which a telephone handset is lifted from its cradle, indicating that the line is engaged in a call. When the handset is off-hook, the circuit is closed, allowing communication to take place.
