The only place you'll find concrete on the "average house" is its footing. The average house footing will contain between 5 and 8 cubic yards (3.8 and 6.1 cubic meters) of concrete. Note: house footings contain very little or no reinforcement.
Hoover Dam contains 3,333,459.2 cubic meters of concrete.
Concrete is sold in cubic (volume) measurements not square (area) measurements.
average of 0.12tons of rebars per cubic meter of concrete.
The weight of reinforced concrete varies depending upon the mix type. The engineering industry typically assumes a weight of 145 pounds per cubic foot (pcf) and most often uses 150 pcf for structural calculations. Note that this is for standard cured reinforced concrete. Lightweight concrete is generally taken as 110 to 120 pcf, again, depending upon the mix design. The fact that there is sometimes more or less steel reinforcement within the structural member is ignored.
Concrete now comes in cubic meters. There is 2.2 tons to each cubic meter of concrete plus whatever the size if the truck is. An 8 meter truck is about 32 tons full, 6 meter truck is about 26 tons full and a minni mix (4 meters) is about 22 tons full. This is just a rough guide. Regards Colin
o
39 cubic yards is 29.81 cubic meters.
It is about 150 to 180 kilograms per cubic meter of 60 MPa concrete
Hoover Dam contains 3,333,459.2 cubic meters of concrete.
Ready mix concrete is usually delivered by a concrete mixer, once delivered it is ready to use immediately. One cubic meter will cost around USD $160.
Concrete is sold in cubic (volume) measurements not square (area) measurements.
1.35
100 cubic meters.
That is an area measurement, whereas concrete is measured in volume, typically cubic yards in the US. The costs vary widely based on local availiblity of materials and the type of concrete mix. The national average is about $100 for a cubic yard of concrete.
None. Concrete may be formed without metal.If you are reinforcing the concrete with rebar then it depends on what loads the reinforced concrete will have to bear, the dimension of the rebar, the safety factor involved, and lots of other geometric factors.Steel bars quantity will be according to structure element; but a (very) rough average of 120 KG per cubic meter.
compare 0.76 cubic meter to kilogram
It depends on the type of structure according to the load subjected