The voltage required to make an arc of 0.5cm can vary depending on factors such as air density and humidity. However, as a general guide, a voltage of around 3,000 to 10,000 volts may be needed to create an arc of 0.5cm in air at atmospheric pressure.
It typically takes around 30,000 to 50,000 volts to create an arc of 0.5 cm in air. The exact voltage required can vary based on factors such as humidity and air pressure.
There are different arc lengths for different types and size breakers. The length of the arc is governed by the physical distance of the contact openings and the efficiency of the arc chutes to extinguish the arc.
The highest temperature recorded from an arc flash can exceed 35,000Β°F (19,400Β°C). This extreme heat can cause severe burns and damage to equipment within a fraction of a second. It is crucial to take necessary precautions to prevent arc flash incidents.
None.A square yard is a measure of area in 2-dimensional space whereas an arc is a curved line segment. There can be no conversion between the two.
The voltage required to make an arc of 0.5cm can vary depending on factors such as air density and humidity. However, as a general guide, a voltage of around 3,000 to 10,000 volts may be needed to create an arc of 0.5cm in air at atmospheric pressure.
It typically takes around 30,000 to 50,000 volts to create an arc of 0.5 cm in air. The exact voltage required can vary based on factors such as humidity and air pressure.
My understanding is that it takes about 20,000 volts to arc between the two parts of the spark plug and most automotive coil put out 20,000-50,000 volts.
If you are talking about 12 volts dc, then NO, there is not enough voltage to shock you. Actually, it would take about 40 or more volts to start to get a shock. Of course, standing in water would make the voltages less. Even standing in water, 12 volts is not enough to shock you.
This varies a lot with the conditions and can be between 10,000V to 30,000V per inch of air gap: Are the electrodes pointed? If yes, then on the low end of the range. The voltage increases with air pressure. Humidity and particulate matter also affect the voltage required to strike an arc.
can, car, van, arc, ran
it took 400.5 people to build the Arc de Triomphe
How do you make a simple plazma arc using tungsten wire.
Arch,Arm,Harm,Charm,Arc.
60
An arc
How did Joan of Arc do what? You need to make your question a bit more specific.