A stove is a two pole 50, and hot water heater i would recommend the same.
No, it will not harm the stove.
To determine if the stove plug is tripping the circuit breaker, plug the stove into a different outlet with the same voltage rating. If it doesn't trip the breaker, the issue may be with the original outlet or circuit. If the stove still trips the breaker, it may be a problem with the stove itself. If the circuit breaker seems problematic, consult an electrician to diagnose and fix the issue.
The breaker commonly used for ranges is a 40 amp. This size is used to cover the total wattage of the range. If for some reason all of the top elements and the oven were in use at the same time then the amperage drawn would be just under the trip setting of the breaker. If this same scenario were played out on the range with a 30 amp breaker supplying the power it would trip the breaker.
Electric dryers typically are 220 volts and need a 30 amp, 2-pole circuit breaker. A 15 amp breaker would quickly trip if overloaded with a dryer. You may need a wiring upgrade (to 10 gauge) and a new 2-pole breaker for 30 Amps. You should also not be using two separate breakers for one 220 volt circuit; they should be either one unit or two that have their handles mechanically connected together. Hire an electrician.
The four blade dryer plug brings a separate ground wire from the machine to the electrical grounding system. The three blade dryer plug depended on the neutral wire of the plug to make this connection.
on the stove, oven microwave, a heater, the sun, and dryer
A stove, dryer, water heater, furnace, heat pump.
There is no way of telling from here. It will be a double breaker, most boxes will have 3 doubles. One for the stove, one for the AC and one for the water heater. Process of elimination should tell you which is for the heater.
Normally a new kitchen stove will require a 50 amp breaker wired with AWG # 6/3 with ground wire.
If this is the main service in your home then you probably could not run both appliances at the same time. A range has a 40 amp breaker and a dryer has a 30 amp breaker protecting the feeders to these appliances. Even though both appliances do not draw the maximum current that the breaker allows it would be close. With other devices in use through out the home with the range and dryer on at the same time it will probably trip the panels 60 amp breaker.
who invented the clothes dryer that used heat from the stove
No, it will not harm the stove.
that would really depend upon the stove (I assume that you mean an appliance with an electric cooktop and an electric oven) and the size of the wire present. Most of the time a stove will require a 50amp breaker. This will mean that you would need to have 6 gauge wiring. You can probably get by with a 40 amp breaker and 8 gauge wire if you absolutely had to. Always check the appliance specifications. they will recommend a breaker size.
To determine if the stove plug is tripping the circuit breaker, plug the stove into a different outlet with the same voltage rating. If it doesn't trip the breaker, the issue may be with the original outlet or circuit. If the stove still trips the breaker, it may be a problem with the stove itself. If the circuit breaker seems problematic, consult an electrician to diagnose and fix the issue.
To reset a Whirlpool stove, locate the circuit breaker or unplug the stove for a few minutes, then plug it back in or flip the circuit breaker back on. This should reset the stove and clear any errors or malfunctions.
G T Sampson invented the clothes dryer
To safely install a new wire for your stove, first turn off the power to the stove at the circuit breaker. Then, carefully remove the old wire and install the new wire following the manufacturer's instructions. Make sure to use the correct gauge wire for your stove and secure all connections properly. Finally, turn the power back on and test the stove to ensure it is working correctly.