Want this question answered?
Be notified when an answer is posted
To calculate how many feet of electric baseboard heat you need, you can use the formula: Total heat output (in watts) divided by the wattage per linear foot of the baseboard heater. This will give you the total length of baseboard heater required in feet for your specific heating needs.
Demineralized water is used in boilers to prevent mineral buildup that can lead to scale formation. This helps maintain efficient heat transfer and prevent corrosion in the boiler system. Using demineralized water can also increase the lifespan of the boiler components.
If water gets into an oil boiler, it can cause damage to the boiler components, such as the burner or heat exchanger. This can lead to reduced efficiency, operational issues, and potential breakdowns. It is essential to address this issue promptly by draining and cleaning the boiler to prevent further damage.
Boiler capacity is typically measured in terms of kilowatts (kW) or British Thermal Units per hour (BTU/hr). This measurement helps to determine the amount of heat energy output a boiler can provide to heat a space or produce hot water. It is important to consider the required capacity when selecting a boiler to ensure it meets the heating needs of the building.
When water in a boiler is heated up, it turns into steam. The steam then expands and builds pressure, which can be used to generate power or heat. The boiler is designed to contain and control this process to power various applications such as heating systems or turbines.
It takes about 50,000 btus to heat 1000 square feet
The boiler in a hydronic heating system is just a heat source. An electric or gas water heater could be used as well. Proper design and installation are the key attributes.
waste heat recovery boiler
Electric boilers require approximately 3 1/2 kilowatts per boiler horsepower. Fuel oil typically produces approximately 3.5 boiler horsepower per gallon of oil burned*. *This depends on several factors in boiler design, furnace design and fuel heat content.
what are the 3 ways to transferred heat into a boiler
A 'Triton Electric Shower' is a shower that can draw on a cold water supply and heat it on demand. It differs from other showers in the fact that it can use cold water and heat it itself, instead of relying on a boiler to heat the water first.
I would use an electric boiler and use hot water to heat your floor. It is much more economical. Check with your local plumber and he will give you a quote.
The heat transferred from flames to a boiler depends on several factors such as the temperature of the flames, the surface area of the boiler, and the efficiency of heat transfer. In general, the heat transfer occurs through convection and radiation, with the flames heating the boiler's surface which then heats the water inside.
50,000 btu
form_title=Boiler System Repair form_header=7043 Please describe the type of boiler system which needs repairing*= () Natural gas fired () Propane gas fired () Oil fired () Electric fired How would you describe the nature of the problem? (Select all that apply)*= [] Gas smell [] Power failure [] No heat in one location [] No heat in all locations [] Cracked radiator [] Leaky radiator [] Leaky boiler [] Pilot light out on boiler [] Broken baseboard radiator cover [] Radiant heat pump not functioning [] Hammering noise in radiator [] Too much heat in some locations [] Annual/Preventative Maintenance
I would recommend using a double boiler. If a double boiler is unavailable, I would heat it on low heat and stir it frequently.
An economizer is used to heat boiler feedwater up closer to the temperature of the boiler water, using heat from the boiler exhaust gases, heat that would otherwise be wasted. The main reason is to improve the efficiency of the boiler. For every 44 degree F drop in exhaust gas temp. there is an 11 F rise in feedwater temperature and a 1% gain in boiler efficiency.