Wiki User
∙ 14y agoYes, 12 AWG is good for 25 Amps if copper wire.
If aluminum wire, then good for 20 Amps.
Wiki User
∙ 14y agoFor a 20-amperes circuit, a wire gauge of at least 12 AWG should be used to ensure safe and efficient operation. Choosing the correct wire gauge will help prevent overheating and potential hazards in the circuit.
Wiki User
∙ 11y agoA #12 copper wire, insulation 90 degree is rated at 20 amps.
Wiki User
∙ 14y ago12 American Wire Gauge (AWG). 12 AWG.
Wiki User
∙ 14y ago12 gauge.
Wiki User
∙ 11y agoAWG 12/2 copper.
For a 240V steam generator, it is recommended to use a wire with a gauge of 10 AWG for a 30-amp circuit or gauge 8 AWG for a 40-amp circuit. Make sure the wire is rated for the voltage and amperage of the steam generator, and always consult a professional electrician for proper installation.
An open circuit.
Wind circuit is not a type of home circuit. The common types of home circuits are electrical circuits, lighting circuits, and dedicated circuits.
For a 40 amp 220 volt circuit run 60 feet in a residence, it is recommended to use a #8 AWG copper wire for the wiring. This will ensure that you have a safe and efficient electrical connection for your circuit.
The type of circuit you are describing is known as a simple circuit. It consists of a power source (electric cell), a switch, a conductor (usually wire), and a resistor to control the flow of electric current.
10 AWG
10 gauge
10 AWG
The thickness of copper telephone wires was/is specified by their weight per mile. 80 oz per mile is about 24 gauge in the USA
12 gauge
This is a voltage drop question. To answer this type of question a circuit voltage and the circuit load amperage must be given to calculate an answer.
they are used for more power than a series circuit so you should use this one.
difference between p type and n type semiconducter materialAnswerInsulation is used to prevent a short current. To protect the circuit should a short-circuit fault occur is either a fuse or a circuit breaker.
#6 wire is good for 65 Amps as long as it is type THHN.
It is a resistive type of circuit.
For a 240V steam generator, it is recommended to use a wire with a gauge of 10 AWG for a 30-amp circuit or gauge 8 AWG for a 40-amp circuit. Make sure the wire is rated for the voltage and amperage of the steam generator, and always consult a professional electrician for proper installation.
The best electronic circuit breakers are possibly Square D. Make sure that you specify the sub type, which should be QO and not Homeline or any other type.