A #6 copper conductor will limit the voltage drop to3% or less when supplying 30 amps for 175 feet on a 220 volt system.
Wiki User
∙ 11y agoFor a 175 ampere motor, the recommended minimum wire size would be 2/0 AWG (American Wire Gauge) for copper wire. This size is typically used for high current applications to ensure proper conductivity and prevent overheating of the wires. It's important to consult local electrical codes and regulations to ensure compliance.
For a 175 ft run of underground wiring to a church sign, it is recommended to use 10-2 wiring. This size will ensure that the wiring can handle the voltage drop over the distance without issues.
Assuming you're referring to a standard cup size of 250 ml, there would be approximately 0.7 cups in a 175 ml bottle.
A zero gauge wire can typically handle up to 300 amps of current. However, the exact capacity may vary depending on the specific wire material and insulation used in the wire. It is important to consult the manufacturer's specifications for the wire you are using to determine the exact ampacity.
Coarse dust particles typically range from 10 to 50 micrometers in size, while granules are larger particles ranging from 2 to 4 millimeters in size. The exact size can vary depending on the specific material and how it is produced.
4/0 (4 ought) in copper will handle 250 amps. The voltage drop at 175 ft. is about 2.14 volts which should be okay.
For a 175 ampere motor, the recommended minimum wire size would be 2/0 AWG (American Wire Gauge) for copper wire. This size is typically used for high current applications to ensure proper conductivity and prevent overheating of the wires. It's important to consult local electrical codes and regulations to ensure compliance.
151 + 24 = 175
A 3/0 aluminum conductor will limit the voltage drop to3% or less when supplying 125 amps for 175 feet on a 220 volt system. If the 125 amp load is a sub distribution panel that is not going to be fully loaded to 125 amps then using the exact connected load, which might be smaller than 125 amps will effect the wire sizing. The grounding conductor for that size distribution panel is #6 bare copper.
For a 175 ft run of underground wiring to a church sign, it is recommended to use 10-2 wiring. This size will ensure that the wiring can handle the voltage drop over the distance without issues.
Honda civic 1997 comes out with 175/65r14 size 14inch wheels Honda civic 1997 comes out with 175/65r14 size 14inch wheels
175/65-r14t
175/70r/13
175/70R14 is stock size for the stand neon
Not a good idea. But if you insist they you need to change the aspect ratio. For instance if you have a 215/60-15 tire and want to go to a 175 then you must go with a 175/75-15 to keep the overall diameter close to the same. Otherwise your speedometer will be way off and handling, performance, traction, and fuel mileage will be adversely effected. My advice is to stick with the OEM size.
BB's are all the same size .175 for all the BB guns.
175-70-14