You don't provide enough information to answer your question specifically. If the 20 A breaker is providing 110 Volts it can handle 20 Amps for a time. For continuous use you don't want to exceed 16 Amps. As long as your two 110 Volt devices draw less than a total of 16 Amps when you add the current rating of each device, then you are okay.
Yes, it can.
and breakers that can only hold up to 250 volts
If you are talking about normal house hold voltage it would depend in which country you live in. For North America it would be 120/240 volts. For Europe and Eastern countries it would be 240 volts. Industrial voltages vary from country to country. These normal voltages range from 120, 277, 240, 347, 415, 480, to 600 volts.
The voltage a capacitor can hold is determined by its capacitance, which is measured in farads. The formula relating voltage (V), capacitance (C), and charge (Q) is V = Q/C. To determine the capacitance needed for a capacitor to hold 100 volts, you would rearrange the formula to be C = Q/V, so with Q being a value assigned to the amount of charge you'd like the capacitor to hold (e.g. in coulombs), you'd rearrange to be C = Q/100.
Most household appliances use either 120 volts or 240 volts, depending on the country and the type of appliance. In the United States, most outlets provide 120 volts for small appliances and lighting, while larger appliances like stoves and dryers require 240 volts.
Yes, it can.
ITS SHOULN'T BE JUST A FUSE IT SHOULD HAVE A CIRCUIT BREAKER TOO. THE CIRCUIT BREAKER OPENS IF YOU HOLD THE SWITCH TOO LONG. ITS 20AMP ON MOST CARS THAT I WORKED ON. ITS IN THE FUSEPANEL ON MUSTANGS. GOOD LUCK PAUL G
Volts? Well my friend, i can hold 5 tons and only use the small amount of voltage running through my body...be more specific.Kadius1964~blog me.
and breakers that can only hold up to 250 volts
12 volts to hold open the shut-down solenoid
Sure. Electricity can hold any amount of electricity.
20000 volts
your generator may be putting out too much voltage. that is it should be 115-125 volts check it with a voltmetet when running under load. also if a surge of load occurs, the breakers may not be overloaded in normal running conditions, but if a motor starts, it's starting load may be more than the breaker can hold. you may have to size the breaker for the starting motor load, not the running load also, if your generator is running on low voltage, that will increase the amperage on the served appliances. the breaker will then trip
You would have to have a capacitor rated for 100 million volts, and you would have to have a 100 million volt power supply. Before even considering this idea, consider this; the limit of approach for a conductor at 500,000 volts, is 20 feet. This means that within 20 feet of a conductor where this voltage is present, it can arc to you and kill you. At 100 million volts, well, you're typical lightning strike is 100 million volts. The lightning bolt travels miles through the air which it ionizes.
If you are talking about normal house hold voltage it would depend in which country you live in. For North America it would be 120/240 volts. For Europe and Eastern countries it would be 240 volts. Industrial voltages vary from country to country. These normal voltages range from 120, 277, 240, 347, 415, 480, to 600 volts.
9200 volts my 1000 uF capacitor only holds 10 volts
Use a breaker bar and appropriate sized socket Use a breaker bar and appropriate sized socket