Probably not. It would depend on several factors. I would expect that the filament resistance is somewhat dependent on temperature. So if you had a longer duty cycle between switching events the filament would cool down more and perhaps have less resistance. Theoretically if you had a temperature controlled resistance and could do perfect switching then you could probably get it to where the power usage was the same.
Either you are unlucky or you buying cheap bulbs.
It would depend on the number of incandescent bulbs currently in use and the wattage of each bulb. Fluorescent bulbs typically use about 25-80% less energy than incandescent bulbs, so you would need fewer fluorescent bulbs to replace all the incandescent bulbs.
Yes, it would cost more to run four 25-watt bulbs than one 100-watt bulb. The total wattage for four 25-watt bulbs is 100 watts, the same as one 100-watt bulb. However, the four bulbs would consume more energy overall due to the increased electrical resistance and potential inefficiencies of multiple bulbs.
Hyacinths are grown from bulbs.
Assuming each 75-watt bulb draws 0.625 amps (75 watts / 120 volts), a 20-amp breaker can handle up to 32 such bulbs (20 amps / 0.625 amps per bulb). However, it is recommended to not exceed 80% of the breaker's capacity, so in practical terms, around 25-26 bulbs would be a safe maximum to ensure the breaker does not overload.
Intermittent flashing of LED bulbs can be caused by issues such as incompatible dimmer switches, loose connections, or voltage fluctuations. It is important to check the compatibility of the bulbs with the dimmer switch and ensure all connections are secure to troubleshoot the problem.
You have one of two issues. The first is one of the front or rear bulbs are burned out. the second is the flasher is bad. I would bet it is the first one. Watch the bulbs that are flashing on the left side, then you will know which bulb is out on the right side.
Hi check that your bulbs are all flashing if they are it could be the indicator stark scrap yard should have some in or ebay.
Check all bulbs Perhaps flasher is defective
They're the flash bulbs from cameras.
Intermittent flashing of LED light bulbs can be caused by issues such as loose connections, incompatible dimmer switches, or electrical interference. It is recommended to check the connections, try a different dimmer switch, or consult an electrician for further assistance.
Check two things: 1) the fuse for your flashers/blinkers and 2) that the bulbs are good still.
No. It is legal only if the bulbs are NOT red OR flashing. also the bulbs can not be showing. Other than that your fine. Im putting blue streetglow on my 05 mustang.
It depends on how often the bulbs are used. Tanning bulbs last a lot longer when they are not constantly on. Tanning beds in general are expensive to maintain. You will have a high electric bill and bulbs are expensive.
you have bulbs burnt out either on the front or rear of your car or your flasher is going bad
Check the bulbs first. This is usually an indication of a bad bulb. If all the bulbs light, turn on the headlights and check again. The bulb that won't light has no ground connection. With the headlights off, the circuit was completed through the headlight. The turn signal switch might also be bad. But the flasher is good, since it works on the left.
Check the light bulbs to see if the filament is intact. If not replace the bulb. If your bulbs seem to be ok, you may need a new flasher.