0
300J of work are required to fully drive a stake into the ground If the average resistive force on the stake by the ground is 716 N how long is the stake?
In physics, Work = Force x Distance (W=Fd)
We know that:
W = 300 J
F = 716 N
We dont know:
d = ?
The equation we will use is W = Fd
Substituting in for what we know:
300 J = (716 N) x d
Rearranging for d:
d = (300 J)/(716 N)
Solving for d:
d = 0.419 m
What this tells us is that the distance the stake was pounded into the ground is 0.419 meters. We cannot determine the length of the stake without knowing more information.
What else can I help you with?
What is your average speed if you drive 252 km h for a half hour and then drive 36 km h for an hour and a half?
90
How long does it take to drive 121 miles?
Depends on average rate of speed...
If you drive 424 miles in 8 hours what will be your average speed?
53 mph
How long will it take to drive 149 miles?
It will depend on the average speed at which you travel.
How long does it take to drive 64km?
It will depend on the average speed with which the journey is undertaken.
How many quartz of transmission fluid will be required at filter change on 4.7 dodge 2 wheele drive?
Between four and six is average.
What is the OBDII drive cycle for a Jeep Wrangler?
The average Jeep computer takes about 20-30 minutes of driving to perform all the required tests.
Is a driver's license required to drive a vehicle?
Yes, a driver's license is required to legally drive a vehicle on public roads.
What is an average golf drive?
Golf Digest studies show that the average golfers drive is 205 yards. the average PGA players drive is about 290 yards.
Fly the plane or drive the plane?
Both - you fly it in the air, but you drive it on the ground.
How many hp is required to drive an alternator?
The more load that is put on the alternator the more power is required to drive it. This is an interesting question and I really do not have the exact number. But I do know from spinning an alternator with my hand that is takes very little power to turn it when it is not connected to anything. But connect it to a battery that is dead and it takes some power to spin it. I would estimate it takes from 2-3 hp depending on the load. #2 Approximately 1 HP is required to drive an alternator for every 746 watts of electrical power it produces. In practice 1 HP of mechanical power produces a little less than 746 watts at the output because of frictional and resistive losses.
Are you required to have auto insurance on a car that you dont drive?
If the car if financed, the lender will require you to insure it. If you own the car, and don't drive it, you are not required to have insurance.
How long will it take to drive sixty three miles?
One hour if you drive at an average speed of 63 mph.Half an hour if you drive at an average speed of 126 mph.Two hours if you drive at an average speed of 31.5 mph.
What is a ruck?
In rugby, a loose scrum formed around the ball when it is on the ground .
What is the average drive time from Vancouver to Whistler?
The average drive time from Vancouver to Whistler is about 2 hours.
What were factors of production required to drive the industrial revolution?
What were three factors of production required to drive the industrial revolution? that is not an answer the answer is: Land, labor, and capital _______________ that is correct, thanks
What licenses are required to drive flatbed trailers?
Licenses required to drive flatbed trailers vary depending on the size of the trailer. You may not need an additional license.
