answersLogoWhite

0


Best Answer

Number 0 is used at the end of an IPv4 address for network identifiers and number 255 is used at end of an IPv4 for broadcast addresses.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Explain what the number 0 and the number 255 are used for in IPv4 addressing?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Which IP addressing format is used in India?

IPv4


The most widely used IP addressing scheme is?

IPv4


On Which layer of the OSI model is IPv4 Addressing included?

Layer 3 i.e, network layer of the OSI model is used to IP addressing.


Why we use ipv4 not ipv6?

IPv4 was the first used network addressing scheme from the 1970s. IPv6 is newer and not compatible with version 4. It will take some time to upgrade the software and equipment to be able to fully use v6.


Which number system is used for addressing?

number addressing (NA) is the Internet addressing system which is similar to letter addressing system.


What technology is used by private network ranges that has extended the useful life of Ipv4 addressing and slowed the adoption rate of Ipv6?

The technology is used by private network ranges that has extended the useful life of Ipv4 addressing and slowed the adoption rate of Ipv6 is NAT . NAT is short for network address translation. NAT provides mapping between private and universal addresses.


The Class B IPv4 address network ID is located in the?

The first 16 bits is the location of the Class B IPv4 address network ID based in classful addressing. 16 bit is an expression used for microcomputers with 16-bit microprocessors.


What is ipv4 protocol?

Well IPv4 is actually just part of the protocol TCP/IP or Transmission Control Protocol / Internet Protocol. IPv4 is the current addressing scheme used by TCP/IP. The newer IPv6 has been rolling out to eventually replace IPv4. Back to what it is… IPv4 is a 32 bit binary addressing scheme by which every computer on the public Internet (most commonly HTTP) or web servers must be assigned a unique address. The address format is comprised of four sets of 8 bit numbers, more commonly referred to as an octet. So 4 * 8 binary numbers give you a 32 bit IPv4 binary address. Because these numbers are binary each place value only has two possibilities, 0 or 1. Because there are only around 4.3 billion addresses available with 2^32 possible IPv4 addresses a new IPv6 was developed which gives a 128 bit addresses space. This should last until there is no room to stand anywhere on the planet. To summarize IPv4 is not a protocol but an addressing scheme that TCP/IP uses to transmit data packets over the Internet or over a private network. Every computer that is directly connected to the Internet needs a unique address. There are what is known as private IPv4 addresses, different topic, and finally IPv4 will eventually be replaced by IPv6.


What two methods are used to assign an IP address to a host?

There are two protocols used for IP addressing . These protocols are IP version 4 and IP version 6. Other than these two protocols DNS is also used to map IP addresses to name .


What is the most widely used ip standard?

IP version 4, i.e. IPv4 is most prevalent today.


What is the most recent and largest address space IP addressing scheme?

IP version 6, also known as IPv6, IP next generation, or IPng. It uses addresses of 16 bytes, instead of the 4 bytes used in IPv4.


The most recent and largest addresses space IP addressing scheme is?

IP version 6, also known as IPv6, IP next generation, or IPng. It uses addresses of 16 bytes, instead of the 4 bytes used in IPv4.