You need to look at a steam table first then Multiply lbs/hr steam x latent heat of evaporation in BTU/lb @ the operating pressure.
Steam is nothing but a homogeneous mixture of water & air
for converting cubic meter to ton , density or specific volume is needed. specific volume unite is m3/kg. steam cubic meter/ (cubic meter/kg)= steam (kg ) /1000= tone of steam
It depends on the temperature of the steam, which, in turn, will depend on the pressure.
Steam with a dryness fraction of 0.504 consists of 50.4% steam and 49.6% water.
To calculate the conversion of steam to condensate, you can use the formula: Steam Converted to Condensate = Steam Inlet - Steam Outlet This formula subtracts the amount of steam leaving the system (Steam Outlet) from the amount of steam entering the system (Steam Inlet) to determine the amount of steam that has been converted to condensate.
whenever steam is utilised as heating media, steam condensate is produced.This steam condensatecan be utilsed for steam generation at some other location and needs to be pumped, for pumping you need some intermediate storage of this condensate. For storing it we use condensate pot whose level can be controlled.
An inverted steam trap works by allowing condensate to flow out of the system while preventing steam from escaping. When condensate builds up, the trap closes and prevents steam from passing through until the condensate is released. This helps maintain efficient operation by removing unwanted condensate and maintaining steam within the system.
condensate,bleed line of all condensate
Condensate is what you get when you condense steam (water) that was heated in a boiler to make the steam. I'm not sure what else you are looking for.
The number of pounds in a gallon of water changes with temperature. At 100 degrees Celsius, there is about 8 lbs. per gallon of water. So with one thousand lbs. of steam, we would have around 125 gallons of water.
whenever steam is utilised as heating media, steam condensate is produced.This steam condensatecan be utilsed for steam generation at some other location and needs to be pumped, for pumping you need some intermediate storage of this condensate. For storing it we use condensate pot whose level can be controlled.
The specific gravity of steam condensate is typically very close to 1.00, which means it is very close to the density of pure water at the same temperature. This is because steam condensate is essentially just water that has cooled and condensed from its gaseous form.
A device that will allow cooler condensate to pass and hold back the higher temperature steam
If the steam pressure is 25 bars the condensate pressure is at most 25 bars. Typically it is slightly less due to friction of the fluid passing through the steam traps. As the condensate approaches the condensate tank, where it is normally vented to atmosphere, the pressure decreases in the system to near atmospheric.
water receives heat to become vapour thus carrying energy . water is mainly used because it is plentiful and has very high latent heat of vapourisation which absorbs a hell lot of heat during evaporation. here heat energy is converted into pressure energy during heating formation of steam and then expanded in turbines or let out to get kinetic energy as the output.
It works on the principle that condensate at a given temperature will flash to steam after pressure has been significantly reduced.