1,000
== == A square foot is a (two dimensional) measure of area, while a ton is a measure of weight. The two do not equate. On the other hand, a ton of a specific substance could have a specific (three dimensional) volume. For instance, if a one cubic foot concrete block weighed 100 pounds, 20 concrete blocks would equal a (US) ton.
Well, darling, one ton of cement is equal to 1000 kilograms. So, if you're looking to make a ton of cement, you better have those 1000 kilograms ready to go. Don't skimp on the measurements, honey, or your concrete dreams will come crashing down.
how many brass 1 ton
How many CFM for one ton of cooling
there are 31.754 gallons in one ton
It would depend on what item the ton is comprised of. The area of a ton of feathers would be greater than the area of a ton of concrete. Answer 2 It would also very much depend on how thick the material was. A ton of feathers might take up less room than a ton of concrete if the feathers were a mile high and the concrete was an inch thick.
== == A square foot is a (two dimensional) measure of area, while a ton is a measure of weight. The two do not equate. On the other hand, a ton of a specific substance could have a specific (three dimensional) volume. For instance, if a one cubic foot concrete block weighed 100 pounds, 20 concrete blocks would equal a (US) ton.
1000 blocks.
A ton of concrete weighs approximately 2,000 pounds or 907 kilograms.
400
2240
2million
The number of blocks a ton of sand can lay depends on the size of the blocks and the amount of sand needed for each block. Typically, a standard concrete block weighs about 30-40 pounds, and it might require around 0.5 to 1 cubic foot of sand for mortar depending on the mix. On average, one ton of sand (approximately 1 cubic yard) can lay between 100 to 150 standard blocks, assuming efficient use of mortar. However, this can vary based on specific project requirements and block dimensions.
1
A 4 inch block typically weighs around 4 pounds, depending on the material it is made of (e.g., concrete, wood, or foam).
A ton is a measure of weight or mass. An inch is a measure of length. One can not be converted to the other.
The answer depends on the footprint of the equipment.