0
What else can I help you with?
How many 500ml of bottle water would it take to make a liter?
To make a liter of water, you would need two 500ml bottles of water. This is because 1 liter is equivalent to 1000ml. Therefore, two 500ml bottles combined would give you a total of 1000ml or 1 liter of water.
How many 16.9 bottles of Aquafina water make a liter?
9
How much more water is needed to fill the jug to 1 liter?
Well, isn't that a lovely question! It sounds like you're working on something special. To fill the jug to 1 liter, you may want to measure how much water is already in the jug and then add enough water to reach that 1 liter mark. Just a little bit more patience and care, and you'll have that jug filled up just right.
How many meters make 1 liter?
1000
How many bottles of 50cl fill 1 liter?
Well, isn't that a happy little question! If you have bottles that are 50cl each, you would need 2 of them to fill up 1 liter. You see, 1 liter is equal to 100cl, so two 50cl bottles would be just the ticket to make a full liter. Just remember, there are no mistakes, just happy little accidents!
How many 500ml of bottle water would it take to make a liter?
To make a liter of water, you would need two 500ml bottles of water. This is because 1 liter is equivalent to 1000ml. Therefore, two 500ml bottles combined would give you a total of 1000ml or 1 liter of water.
5 liter greater than 5 milliliters or less?
It takes 1,000 milliliters to make just 1 liter. Surely 5 milliliters is not enough to make 5 liters.
How many drops of water make 11 ml?
11mL is 220 drops (20 drops per mL).
How many grams of NaOH do you need to make 1 liter of a 10 percent sodium hudroxide solution?
To make a 10% NaOH solution, you would need 100 grams of NaOH per liter of water. So to make 1 liter, you would need 100 grams of NaOH.
How many ounces of water make a liter of water?
One liter of water is equal to about 33.8 fluid ounces.
How much chlorine do you need to mix a solution in a 15 ounce spray bottle of water?
To disinfect water in a spray bottle, you typically need around 2 to 3 drops of bleach per quart of water or 4 to 6 drops per liter. For a 15-ounce bottle (which is approximately 450 ml), you would need about 6 to 9 drops of bleach. Make sure to use unscented bleach and let the solution sit for at least 30 minutes before use.
Which mass of KCI would you add to water to make a 2 liter of a 1.20 M solution?
179g
How do you make a tornado in a bottle board?
To make a tornado in a bottle, fill a 2-liter bottle with water, add a few drops of dish soap, and swirl the water to create a vortex. Optionally, you can paint the bottle with clouds and a landscape scene to make it into a "tornado in a bottle board" for educational purposes.
What does drops of water form?
a lot of them make puddles.
How many 8oz cups of water make up a liter?
1 liter = 4.22 cups 1 cup = 0.23 liter
How do you make 1molar solution of sodium?
To make a 1 molar solution of sodium (Na), you would dissolve 23 grams of sodium metal into enough water to make 1 liter of solution. This would provide you with a solution where the concentration of Na ions is 1 mole per liter. Note that sodium is highly reactive with water, so the process should be done with caution.
Can you prepare 1 liter of a .5-molar glucose solution?
To prepare a 0.5 M glucose solution in 1 liter of water, you would need to dissolve 90.08 grams of glucose in enough water to make up the total volume of 1 liter. Start by weighing out 90.08 grams of glucose, add it to a container, and then add enough water to make the total volume up to 1 liter.
