First, take a cross-section of the cylinder and measure the area of the resulting circle that is filled with liquid (see http://www.ajdesigner.com/phphydraulicradius/hydraulic_radius_equation_pipe.php for the formula), then multiply the filled area by the length of the horizontal cylinder. To calculate the total volume of the empty horizontal cylinder, the formula is: pi * radius2 * length. For example, if the cylinder/pipe is exactly half full, the formula would be: (pi * radius2 / 2) * length. Of course, it's easier if the cylinder is upright/vertical. Then, you would just take the area of the circle and multiply by the height of the liquid from its base.
The letter H has two lines of symmetry. One in the vertical position, and one horizontal position.
Vertical means up and down. A horizontal line goes from the left to the right (or from the right to the left) like this: ----------------------------- A horizontal line goes from a position that is low to a position that is high (or from a position that is high to a position that is low) like this: | | | | | | | | But the word "vertical" does not tell you which direction the line is drawn, just the it is a line.
5 is in the unit position 1 is in the tens position 7 is in the hundreds position 0 is in the thousands position 3 is in the ten thousands position 6 is in the hundred thousands position 2 is in the million place (which is the thousand thousands position)
What is the antonym of position
5321.0978 (is the example) 5 is in the thousands position (1,000) 3 is in the hundreds position (100) 2 is in the tens position (10) 1 is in the ones position (1) 0 is in the TENTH'S (1/10) position 9 is in the HUNDREDTH'S (1/100) position 7 is in the THOUSANDTH's (/1000) position 8 is in the TEN-THOUSANDTH'S (10000) position
Horizontal position is strate 90 degree
horizontal recumbent assosiated as supine position
the word horizontal means: flat or level: a horizontal position. "The line is horizontal to the ground" would work.....
The cylinder position sensor is located in the distributor.
decubitis
No. It is not uncommon for the layers to be shifted out of a horizontal position.
The straight level line is said to be horizontal.
A cast to horizontal on the uneven bars is when you push your body away from the bar so that your body is in a hollow, horizontal position. Another Answer: Horizontal is not an actual skill in gymnastics. It is the position you are in when you cast. Your cast becomes horizontal when you push yourself high enough off the bar to where you are completely straight across, like the horizon. Another position is vertical, where you are completely up and down.
The volume of a cylinder (with a radius of r and a length L ) in the horizontal position filled to a depth (d) can be calculated with the following formula:L((r2)*(arcos((r-d)/r)) - (r-d)*sqrt(2rd-d2))Note: Calculator must be set to work in radians as opposed to degrees
Vertical is defined as the direction or position that is perpendicular to the plane. Horizontal is defined as to be parallel to the horizon.
The Horizontal recumbent position is a particular position one takes when laying down, usually in regards to medical studies. It involves laying on one's back, knees bent up and legs spread apart.
A cylinder doesn't move, it has one position.